DIGITECH Audio AC-1401 Manual do utilizador - Página 3
Procurar online ou descarregar pdf Manual do utilizador para Interruptor DIGITECH Audio AC-1401. DIGITECH Audio AC-1401 4 páginas. A/b stereo speaker switch wall plate
Imprimir página
Mounting the wall connector on a
partition
1. Mark a 1
3
/
inch × 4 inch (4.4cm×10.2cm) outline
4
on the wall.
2. Drill a
3
/
inch (1 cm) hole in one corner of the
8
outline.
3. Use a saber or keyhole saw to cut along the
outline, then remove the cut-out portion.
4. Use a plier to bend off four rings on the top/bottom of the selector switch's
mounting bracket. These four rings hinder the mounting bracket to
completely contact with the
formed strip.
5. Assemble the two mounting
brackets (formed and flat strips)
using the four supplied medium
screws. Then place the
assembled brackets in the
opening and twist them to fit the
opening. Tighten the four screws
to secure the assembly.
6. Insert the two supplied short screws into the screw holes on the wall
plate and center holes on the molded brackets, then tighten the screws.
F l a t S t r i p
F o r m e d S t r i p
T i g h t e n
M e d i u m
S c r e w s
C u t O u t i n W a l l
Operation
1. Turn on your stereo equipment.
2. To listen to only system A or B speaker, press the
corresponding selector switch A or B.
3. To hear both speaker systems at the same time,
press in both switches.
4 . 4 c m
( 1 - 3 / 4 " )
1 c m ( 3 / 8 " )
.
H o l e