Cisco 2600XM Series Ficha de dados - Página 8
Procurar online ou descarregar pdf Ficha de dados para Hardware de rede Cisco 2600XM Series. Cisco 2600XM Series 11 páginas. Including license and warranty
Também para Cisco 2600XM Series: Manual de início rápido (29 páginas), Ficha de dados (6 páginas), Manual de início rápido (29 páginas)
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Category
Cisco IP Transfer Point Capability
MAP gateway SIM
SIM-based authentication and authorization using RADIUS vendor-specific attributes interface.
authentication and
authorization
MO Proxy
Enables the ability to route segmented GSM MAPv2 and higher messages based on application-
layer parameters by terminating the MO dialogue. This capability ensures that the SMS MO
dialogues for a given B-address are handled by the same SMSC. MO-Proxy is incompatible with the
MMSC Gateway feature.
ITP Group
The ITP Group feature provides the ability to use a single point code to represent a mated-pair of
Cisco ITP signaling gateways and the application server client. The feature is available on the Cisco
2651, 7200, and 7301 platforms. The two Cisco ITPs must be identical platforms and must be
collocated with a direct Ethernet interface connection. The maximum links supported by the Cisco
ITP Group is the maximum supported by the single individual platform.
Preventive Cyclic
The Cisco ITP supports this additional MTP2-layer error correction algorithm which is often used for
Redundancy (PCR)
satellite-based SS7 links where one-way propagation delays can exceed 40ms.
Network management
Simple Network Management Protocol (SNMP)-based network management for nodes, links, and
and monitoring
routes (using a GUI); interoperates with CiscoWorks, CiscoView, HP OpenView products.
Table 6.
IP Routing Protocols
Protocol
Definition
BGP
Border Gateway Protocol
EGP
Exterior Gateway Protocol
EIGRP
Enhanced Interior Gateway Routing Protocol
HSRP
Hot Standby Routing Protocol
IGRP
Interior Gateway Routing Protocol
NHRP
Next Hop Resolution Protocol
OSPF
Open Shortest Path First
RIP
Routing Information Protocol
Static Routing
Provision static routes
Table 7.
Standard Cisco IOS Software QoS Features
QoS Feature
Description
BACP
Bandwidth Allocation Control Protocol
Class-based queuing
Class-based Ethernet class-of-service (CoS) matching and marking, class-based policy for
Differentiated Services (DiffServ) assured forwarding per-hop behavior, class-based Weighted Fair
Queuing, class-based marking, class-based shaping
CAR
Committed access rate
DiffServ
DiffServ-compliant Weighted Random Early Detection (WRED)
Flow-based WRED
Flow-based WRED
Generic traffic shaping
Generic traffic shaping
LLQ
Low Latency Queuing
PBR
Policy-Based Routing
RED/WRED
Random Early Detection/WRED
SPD
Selective Packet Discard
Note:
Not all IP features listed in Tables 6–8 are available when the "VIP offload" feature is
utilized.
Table 8.
Other Cisco IOS Software Features in the Cisco ITP
Feature
Description
AAA
Authentication, authorization, and accounting
Access lists
Access lists
Cisco Discovery Protocol
Cisco Discovery Protocol
Data Sheet
Page 8 of 11