Sony XDCAM PDW-HR1 Manual de instalação - Página 12
Procurar online ou descarregar pdf Manual de instalação para Câmara de vídeo Sony XDCAM PDW-HR1. Sony XDCAM PDW-HR1 16 páginas. Sxs memory card adaptor
Também para Sony XDCAM PDW-HR1: Brochura e especificações (28 páginas), Manual de operação (49 páginas), Brochura (4 páginas)
Imprimir página
14. When the TSI-60A board was removed in step 9,
install it by reversing the steps of removal.
When the TSI-60A board is not mounted, attach the
harness cover with the supplied four screws.
Harness cover
B2.6 x 3
15. While pulling out the coaxial cable from the location
shown in the figure, insert the VPR-15 board into the
slot.
16. Push the VPR-15 board into the slot until its connec-
tors are firmly connected to the MB-1138 board con-
nectors, and then secure the VPR-15 board with two
screws.
Viewed from the
arrow A direction
Coaxial cable
Connectors
PS2.6 x 5
VPR-15 board
1-4 (E)
B2.6 x 3
VPR-15 board
A
Connectors
(MB-1138 board)
17. While pulling out the harness (IF-DPR) from the
location shown in the figure, insert the NET-5 board
into the slot.
18. Push the NET-5 board into the slot until its connectors
are firmly connected to the MB-1138 board connectors,
and then secure the NET-5 board with two screws.
Viewed from the
arrow A direction
Harness
(IF-DPR)
Connectors
PS2.6 x 5
NET-5 board
19. Connect the connector CN3400 on the DPR-321 board
(MK1 assembly) to the connector CN100 on the
HRP-31 board.
20. Install the DPR-321 board (MK1 assembly) with eight
screws.
n
. First install the screw shown in the figure.
. Eight terminals (onboard contact) are mounted on
the DPR-321 board. Handle the DPR-321 board
carefully.
Terminals
PSW2.6 x 6
(on board contact)
CN3400
Terminals
(on board contact)
CN100
HPR-31 board
A
Connectors
(MB-1138)
PSW2.6 x 6
Tighten this screw first.
DPR-321 board
(MK1 assembly)
PDBK-MK1