Cisco 3600 Series Manual de configuração - Página 14

Procurar online ou descarregar pdf Manual de configuração para Hardware de rede Cisco 3600 Series. Cisco 3600 Series 36 páginas. Memory upgrade
Também para Cisco 3600 Series: Visão geral do produto (10 páginas), Instruções de atualização (30 páginas), Manual do Proprietário (17 páginas), Nota de aplicação (41 páginas), Manual do utilizador (25 páginas), Apêndice (15 páginas), Manual do utilizador (7 páginas), Manual (5 páginas), Nota de configuração (23 páginas), Nota de configuração (18 páginas), Nota de configuração (25 páginas)

Configure Dial Peers

The key point to understanding how Voice over IP functions is to understand dial peers. Each dial

peer defines the characteristics associated with a call leg, as shown in Figure 6 and Figure 7. A call

leg is a discrete segment of a call connection that lies between two points in the connection. All the

call legs for a particular connection have the same connection ID.

There are two different kinds of dial peers:

•

POTS—Dial peer describing the characteristics of a traditional telephony network connection.

POTS peers point to a particular voice port on a voice network device.

•

VoIP—Dial peer describing the characteristics of a packet network connection; in the case of

Voice over IP, this is an IP network. VoIP peers point to specific VoIP devices.

Four call legs make comprise and end-to-end call—two from the perspective of the source router as

shown in Figure 6, and two from the perspective of the destination router as shown in Figure 7. A

dial peer is associated with each one of these call legs. Dial peers are used to apply attributes to call

legs and to identify call origin and destination. Attributes applied to a call leg include QoS, CODEC,

VAD, and fax rate.

Figure 6

Figure 7

Destination

Inbound versus Outbound Dial Peers

Dial peers are used for both inbound and outbound call legs. It is important to remember that these

terms are defined from the router's perspective. An inbound call leg originates outside the router. An

outbound call leg originates from the router.

For inbound call legs, a dial peer might be associated to the calling number or the port designation.

Outbound call legs always have a dial peer associated with them. The destination pattern is used to

identify the outbound dial peer. The call is associated with the outbound dial peer at setup time.

VC-26

Voice, Video, and Home Applications Configuration Guide

Dial Peer Call Legs from the Perspective of the Source Router

Source

Source router

Call leg for POTS

Dial Peer Call Legs from the Perspective of the Destination Router

IP cloud

Call leg for VoIP

dial peer 2

Call leg for VoIP

Call leg for POTS

dial peer 3

IP cloud

Destination router

Destination

dial peer 4

Source