Cisco 3800 Series Manual de resolução de problemas - Página 3
Procurar online ou descarregar pdf Manual de resolução de problemas para Hardware de rede Cisco 3800 Series. Cisco 3800 Series 15 páginas. Password recovery procedure
Também para Cisco 3800 Series: Ficha de dados (8 páginas), Nota de aplicação (41 páginas), Ficha de dados (20 páginas), Manual de início rápido (40 páginas), Configuração (32 páginas), Manual do utilizador (7 páginas)
Imprimir página
•
•
•
•
Environmental Reporting Features
If the router is operating at an abnormally high temperature, the following message is displayed on the
console screen:
System detected OVERTEMPERATURE condition. Please resolve cooling problem immediately!
Some causes of abnormally high router temperature are:
•
•
•
Take steps to correct the problem. See also the
Racks" section on page 5
OL-5972-01
With the power switch on and the SYS LED steady green, do the fans operate?
If yes, the power system is functioning.
–
If no, check the fans.
–
With the power switch on and the SYS PWR LED (Cisco 3825) or SYS PWR1 or SYS PWR2 LED
(Cisco 3845) off, do the fans operate?
If yes, the router is receiving power. The fans are connected directly to the DC outputs of the
–
power supply.
If no, check the power source and power cable.
–
Does the router shut down after being on a short time?
Check for an environmentally induced shutdown. See the next section,
–
Reporting
Features."
Check the environmental site requirements in the
–
page 3
of
"Preinstallation Requirements and Planning for Cisco 3800 Series
Check for a power supply failure by inspecting the SYS PWR LED on the Cisco 3825 router,
–
or the SYS PWR1 or SYS PWR2 LED on the Cisco 3845 router (depending on which power
supply is active). If the LED is green, the power supply is functional.
Router partially boots, but LEDs do not come on.
–
Check for a power supply failure by inspecting the SYS PWR LED on the Cisco 3825 router or
the SYS PWR1 LED or SYS PWR2 LED on the Cisco 3845 router (depending on which power
supply is active). If the LED is green, the power supply is functional.
If the SYS PWR LED is not on, see the
–
of
"Introduction to Cisco 3800 Series Routers Hardware Documentation"
customer service. For warranty information, see the
Terms" section on page 10
Documentation."
Fan failure
Air conditioning failure in the room
Air blockage to cooling vents
of
"Preinstallation Requirements and Planning for Cisco 3800 Series
"General Site Requirements" section on
"Obtaining Technical Assistance" section on page 12
"Cisco 90-Day Limited Hardware Warranty
of
"Introduction to Cisco 3800 Series Routers Hardware
"Site Environment" section on page 4
Troubleshooting Cisco 3800 Series Routers
Solving Problems
"Environmental
Routers."
for information about
and the
"Equipment
Routers."
3