Cisco 5500 Series Manual de instalação - Página 29
Procurar online ou descarregar pdf Manual de instalação para Hardware de rede Cisco 5500 Series. Cisco 5500 Series 34 páginas. Cisco 8500 series
wireless lan controller
Também para Cisco 5500 Series: Manual de configuração (40 páginas), Manual (19 páginas), Manual de configuração (50 páginas)
Imprimir página
Tools and Equipment Required
To install a power supply unit, you need the following tools and equipment:
•
•
Follow these steps to install a power supply unit.
Locate the empty power supply slot on the controller's back panel. See
Step 1
Figure 19
1
Note
Use a Phillips screwdriver to loosen the captive screw on the slot cover.
Step 2
Remove the slot cover and store it in a safe place for future use.
Step 3
Align the power supply unit with the slot so that the unit's power input receptacle is on the left side of
Step 4
the slot. See
Figure 20
Gently but firmly push the power supply unit into the slot until it is firmly seated in the card electrical
Step 5
connector.
Use a Phillips screwdriver to tighten the captive screw. Do not overtighten.
Step 6
Plug the power cord into the power supply unit and the other end into a grounded 100 to 240 VAC 50/60
Step 7
Hz electrical outlet.
Make sure that both power supply units are turned on.
Step 8
78-18998-01
A power supply unit
A number 1 Phillips screwdriver
Controller Power Supply Slots
1
Slot 1 with power supply
The power supply units are hot swappable.
Figure
20.
Inserting the Power Supply
2
2
Slot 2 with empty power supply slot with cover
Cisco 5500 Series Wireless Controller Installation Guide
Using the Startup Wizard
Figure
19.
29