Cisco 6160 Manual de procedimentos de instalação - Página 27
Procurar online ou descarregar pdf Manual de procedimentos de instalação para Hardware de rede Cisco 6160. Cisco 6160 32 páginas. Without a pots splitter configuration
Também para Cisco 6160: Manual de referência rápida (38 páginas), Manual de instalação do hardware (21 páginas), Notas de instalação e substituição (18 páginas)
Imprimir página
Chapter 4
Installing a Cisco 6160 Without a POTS Splitter Configuration
4.2.15.2.2 Basic Management Setup Example
This is the basic management setup example:
Would you like to enter the initial configuration dialog? [yes/no]: y
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: y
Configuring global parameters:
Enter host name [DSLAM]:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: beansoup
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: beansoup
% Please choose a password that is different from the enable secret
Enter enable password: lab1
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password:
% No defaulting allowed
Enter virtual terminal password: lab
Configure SNMP Network Management? [yes]: y
Current interface summary
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
ATM0/0
Ethernet0/0
ATM0/1
ATM0/2
Enter interface name used to connect to the
management network from the above interface summary: Ethernet0/0
Configuring interface Ethernet0/0:
Configure IP on this interface? [yes]: y
OL-2190-02 B0
--- System Configuration Dialog ---
Community string [public]:
IP-Address
unassigned
unassigned
unassigned
unassigned
IP address for this interface: 172.27.144.141
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.27.0.0, 16 subnet bits; mask is /16
OK? Method Status
NO
unset
up
NO
unset
up
NO
unset
down
NO
unset
down
Cisco 6160 Hardware Installation Guide
Installation Procedures
Protocol
up
up
down
down
4-27