Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota de instalação - Página 13

Procurar online ou descarregar pdf Nota de instalação para Hardware de rede Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 18 páginas. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Também para Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Nota de instalação (14 páginas), Manual de soluções (17 páginas), Nota de instalação (46 páginas), Livro Branco (19 páginas), Descrição (1 páginas), Boletim do produto (6 páginas), Aviso (4 páginas), Ficha de dados (9 páginas), Ficha de dados (18 páginas), Livro Branco (18 páginas), Manual de configuração (8 páginas), Nota de instalação (28 páginas), Manual de resolução de problemas (11 páginas), Manual do utilizador (17 páginas), Nota de instalação (24 páginas), Manual (19 páginas), Nota de instalação (36 páginas)

Imprimir página
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota de instalação
Figure 12
Step 6
Install the supervisor engine in the Catalyst 6500 series switch. (Refer to the Catalyst 6500 Series
Module Installation Guide for installation instructions.)
Note
Note
If you have redundant supervisor engines, return to
page
4, and follow the directions to upgrade the redundant supervisor engine.
Step 7
Enter the show version command to verify the amount of memory on the supervisor engine.
This example shows that the total memory is 128 MB on the supervisor engine:
Console> show version
...<output truncated>
Module Total
------ ------- ------- ------- ------- ------- ------- ----- ----- -----
2
Console>
78-14357-02
MSFC2 Shipped After November 2001—Installing the Securing Screws
WS-X5530
SWITCH LOAD
100%
1%
SUPERVISOR ENGINE I I I
CONSOLE
Verify that the supervisor engine STATUS LED is lit. If the STATUS LED changes from orange
to green, the supervisor engine has successfully completed the boot process and is now online.
If the STATUS LED remains orange or turns red, the supervisor engine has not successfully
completed the boot process and may have encountered an error.
If the LEDs on the supervisor engine front panel are red, remove the supervisor engine, carefully
remove the DIMMs, and reseat the DIMMs in the socket. Push the DIMMs firmly back into the
socket until the retainer springs snap into place.
DRAM
Used
Free
130944K
57916K
73028K
Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note
Step 2
in the
FLASH
Total
Used
Free
16384K
12003K
4381K
Installing the MSFC2
"Removing the MSFC2" section on
NVRAM
Total Used
Free
512K
257K
255K
13