Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota de instalação - Página 18

Procurar online ou descarregar pdf Nota de instalação para Hardware de rede Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 24 páginas. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Também para Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Nota de instalação (14 páginas), Manual de soluções (17 páginas), Nota de instalação (46 páginas), Livro Branco (19 páginas), Descrição (1 páginas), Boletim do produto (6 páginas), Aviso (4 páginas), Ficha de dados (9 páginas), Ficha de dados (18 páginas), Livro Branco (18 páginas), Manual de configuração (8 páginas), Nota de instalação (28 páginas), Manual de resolução de problemas (11 páginas), Nota de instalação (18 páginas), Manual do utilizador (17 páginas), Manual (19 páginas), Nota de instalação (36 páginas)

Imprimir página
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota de instalação

Related Documentation

To understand the Cisco IOS command-line interface and Cisco IOS command modes, refer to
Chapter 2, "Command-Line Interfaces," in the Catalyst 6500 Series Switch Cisco IOS Software
Configuration Guide.
To understand the Catalyst operating system command-line interface and Catalyst operating system
command modes, refer to Chapter 2, "Command-Line Interfaces," in the Catalyst 6500 Series Switch
Configuration Guide.
Unless your switch is located in a fully trusted environment, we recommend that you configure the
module through a Telnet connection using Secure Shell (SSH) encryption.
You can session into the module from the switch console and configure the CSM. The session is a Telnet
interface through the Ethernet out-of-band channel (EOBC) of the switch backplane.
You can also make a Telnet connection into the module from a specified host and on a specific interface.
Telnet support for this host should be configured or enabled from the module console.
Console output is redirected to all active Telnet sessions. When no Telnet session is available, the output
is saved to a buffer. The buffer output can be subsequently examined when you make a Telnet connection
into the module.
Related Documentation
Use this document with the following Cisco documents:
•
•
•
•
•
•

Translated Safety Warnings

Invisible laser radiation present. Statement 1016
Warning
Waarschuwing
Onzichtbare laserstraling aanwezig.
Varoitus
Näkymättömiä lasersäteitä.
Attention
Rayonnement laser actif mais invisible.
Warnung
Unsichtbare Laserstrahlung.
Avvertenza
Radiazione laser invisibile.
Catalyst 6500 Series Switch Content Switching Module Installation Note
18
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide
Catalyst 6500 Series Switch Software Configuration Guide
Catalyst 6500 Series Switch Content Switching Module Command Reference Release 3.2
Catalyst 6500 Series Switch Content Switching Module Installation Guide Release 3.2
Catalyst 6500 Series Switch Content Switching Module and Installation and Configuration Guide
Release 3.2
Release Notes for the Catalyst 6500 Series Switch Content Switching Module Release 3.2.
78-15751-01