Cisco 7200-I/O-GE+E Manual do utilizador - Página 5
Procurar online ou descarregar pdf Manual do utilizador para Hardware de rede Cisco 7200-I/O-GE+E. Cisco 7200-I/O-GE+E 16 páginas. Input/output controllers
Imprimir página
Cisco 7200-I/O-GE+E and Cisco 7200-I/O-2FE/E Input/Output Controllers
3.
Use the interface fastethernet router-shelf/slot/port command for a Cisco 7200 VXR used as a router shelf in an AS5800 Universal Access
Server.
Verifying the Configuration
Use the show interfaces {ethernet | fastethernet | gigabitethernet} command to verify that the
interface and line protocol are in the correct state (up) and the transmission mode is configured on the
interface. You can configure full, half, or auto transmission mode for Ethernet and Fast Ethernet
interfaces. You can configure forced transmission mode for Gigabit Ethernet interfaces. The following
example displays sample output for a show interfaces gigabitethernet command.
Router# show interfaces gigabitethernet 0/0
GigabitEthernet0/0 is up, line protocol is up
Hardware is 82543 (Livengood), address is 00d0.ffb6.4c00 (bia 00d0.ffb6.4c00)
Internet address is 10.1.1.0/0
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex mode, link type is autonegotiation, media type is SX
output flow-control is on, input flow-control is on
ARP type:ARPA, ARP Timeout 04:00:00
Last input 00:00:04, output 00:00:03, output hang never
Last clearing of "show interface" counters never
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
2252 packets input, 135120 bytes, 0 no buffer
Received 2252 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
2631 packets output, 268395 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
Configuration Tasks
12.1(5)T and 12.2(14) S
5