Cisco 7507 Manual de instruções de instalação - Página 20
Procurar online ou descarregar pdf Manual de instruções de instalação para Hardware de rede Cisco 7507. Cisco 7507 39 páginas. Air filter and chassis blower replacement
Também para Cisco 7507: Manual de início rápido (44 páginas), Ficha de dados (11 páginas), Manual de instruções de substituição (21 páginas)
Imprimir página
Installation
Attaching the Chassis Ears
The ears attach directly to the chassis with four M4 x 10-mm, flat-head screws. Attach the ears to
the chassis before you slide the chassis onto the brackets and back into the rack. After you slide the
chassis into the rack, insert a 10-32 x 5/8-inch pan-head screw through each of the captive grommets
on the ears and through the rack-mounting strips. The ears do not bear the weight of the chassis, but
prevent it from walking, or sliding horizontally out of the rack.
You can mount the ears on either the front or rear of the chassis, whichever end will be in the front
of the rack. We recommend that you attach them to the interface processor end of the chassis, so the
power supplies and processor modules will be accessible at the front of the rack.
In most four-post racks, you will attach the ears with the mounting strip flush with the end of the
chassis. Figure 4, on page 6, shows a typical flush-mount installation. In Figure 12, the example
insert on the right shows how the ears attach to the chassis for flush mounting.
In some Telco-type racks, it is more practical to center-mount the chassis. To do so, flip the ears
around so that the mounting strips are near the center of the side of the chassis. Figure 3, on page 5,
shows a typical center-mount installation. In Figure 12, the example insert on the left shows how the
ears attach to the chassis for center mounting.
Figure 12
Center-mount
position
20 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions
Installing the Ears on the Chassis
OR
Flush-mount
position