Sony 838 MHz to 862 MHz Brochura - Página 42

Procurar online ou descarregar pdf Brochura para Câmara digital Sony 838 MHz to 862 MHz. Sony 838 MHz to 862 MHz 48 páginas. Sony digital camera brochure

Imprimir página
Sony 838 MHz to 862 MHz Brochura
Specifications
DIGITAL VTRs
DSR-2000P / DSR-1800P / DSR-1600P / DSR-1500AP
General
Power requirements
Power consumption (Max. )
Operating temperature
Storage temperature
Operating humidity
Storage humidity
Tape speed
Recording/Playback time
Fast forward/Rewind time
Search speed
still to ±60 times normal speed
Mass
Dimensions
(W x H x D, excluding projections)
Video Performance
Bandwidth
Luminance
25 Hz to 5.0 MHz +1.0/-2.0 dB
(via analogue
component I/O)
Chrominance
S/N ratio (via analogue component I/O)
K-factor (K2T, KPB)
Y/C delay 0
Audio Performance
Frequency response
2 CH mode (48 kHz/16-bit)
4 CH mode (32 kHz/12-bit)
Dynamic range
Distortion (THD+N)
Video Signal Inputs
Analogue
Ref. Video
Composite, 1.0 Vp-p, 75 Ω ,
(BNC x2, loop-through connection)
Video (BNC x2, loop-through connection)*
1
Component
Y
(BNC x3) *
1
R-Y
B-Y
1
S-Video *
Digital
SDI *
2
*
3
3
4
SDTI (QSDI) (BNC x1) *
*
i.LINK (DV In/Out) (6-pin x1)*
5
*
6
*
7
Audio Signal Inputs
Analogue
Audio *
1
Digital
AES/EBU *
2
*
3
Video Signal Outputs
Analogue
Ref. Video (BNC x1)
Video
Video 1/2/3 (super) BNC x 3
Component (BNC x3)
S-Video
Digital
SDI *
2
*
3
*
8
SDTI (QSDI) *
3
*
4
*
9
i.LINK (DV In/Out) (6-pin x1) *
5
*
6
*
7
Audio Signal Outputs
Analogue
Audio
-6/0/+4 dBu (selectable by menu)
Monitor
-11 dBu, 47 kΩ , unbalanced
Headphone
(JM-60 headphone jack x1)
Digital
AES/EBU *
2
*
3
*
9
Time Code Input/Output
In (BNC x1)
Out (BNC x1)
Remote
RS-422A: D-sub 9-pin female x2
Video Control: D-sub 15-pin male x1
Control Panel: D-sub 15-pin female x1
Supplied Accessories
RCC-5G 9-pin Remote Control Cable
*1 The optional DSBK-1504 is required for the DSR-1500AP
*2 The optional DSBK1801 is required for the DSR-1800P
*3 The optional DSBK1501 is required for the DSR-1500AP
42
DSR-2000P
110 W
Standard size: 184 min. with PDV-184ME/184N/184MEM Mini size: 40 min. with PDVM-40ME/40N/40MEM
Standard size: Less than 3 min. with PDV-184ME/184N/184MEM Mini size: Less than 1 min. with PDVM-40ME/40N/40MEM
Shuttle mode:
Digital slow mode:
±1 times normal speed
18 kg (39 lb 10 oz)
427 x 175 x 496.5 mm
(16 7/8 x 7 x 19 5/8 inches)
5.75 MHz +0/-3.0 dB
(Typical measurement)
20 Hz to 20 kHz +0.5/-1.0 dB
20 Hz to 14.5 kHz +0.5/-1.0 dB
0.3 Vp-p, 75 Ω , sync negative
sync negative
Composite, 1.0 Vp-p, 75 Ω , sync negative
1.0 Vp-p, 75 Ω , sync negative
0.7 Vp-p, 75 Ω (100 %)
0.7 Vp-p, 75 Ω (100 %)
DIN 4-pin x 1
Y: 1.0 Vp-p, 75 Ω , sync negative
C: 0.3 Vp-p, 75 Ω (at burst level)
BNC x 2, active-through connection
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
Conforms to SDTI (270 Mb/s), SMPTE 305M/322M
IEEE1394-based
XLR 3-pin female x4
-6/0/+4 dBu, 600 Ω on/off/
-6/-3/0/+4 dBu, 600 Ω on/off/
-60 dBu, high impedance
-60 dBu, high impedance
BNC x 2
75 Ω , unbalanced
Y: 1.0 Vp-p, 75 Ω , sync negative
BNC x 3
Phono x 1
(-18 dBFS)
-∞to -13 dBu, 8 Ω ,
unbalanced (-18 dBFS)
AC Power Cord
Operating Instructions
*4 The optional DSBK1802 is required for the DSR-1800P
*5 The optional DSBK-190 is required for the DSR-2000P
*6 The optional DSBK1803 is required for the DSR-1800P/1600P
DSR-1800P
DSR-1600P
AC 100 V to 240 V, 50/60 Hz
100 W
5 °C to 40 °C (41 °F to 104 °F)
-20 °C to 60 °C (-4 °F to 140 °F)
Less than 80%
Less than 90%
28.221 mm/s
Shuttle mode: still to ±60 times normal speed
Digital slow mode: ±0.5 times normal speed
13 kg (28 lb 10 oz)
427 x 174 x 400 mm
(16 7/8 x 6 7/8 x 15 3/4 inches)
25 Hz to 5.0 MHz ±1.0 dB
25 Hz to 2.0 MHz + 1.0/-2.0 dB
More than 55 dB
Less than 2.0%
Less than 30 ns
More than 90 dB
Less than 0.05%
Y: 1.0 Vp-p, 75 Ω , sync negative
C: 0.3 Vp-p, 75 Ω (at burst level)
0.3 Vp-p, 75 Ω , sync negative
Video 1/2(super) BNC x 2
Composite, 1.0 Vp-p, 75 Ω , sync negative
R-Y: 0.7 Vp-p, 75 Ω (100%)
DIN 4-pin x 1
Y: 1.0 Vp-p, 75 Ω , sync negative C: 0.3 Vp-p, 75 Ω (at burst level)
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
BNC x 1
Conforms to SDTI (270 Mb/s), SMPTE 305M/322M
IEEE1394-based
XLR 3-pin male x4
-6/-3/0/+4 dBu (selectable by menu)
-9 dBu, 47 kΩ ,
unbalanced (-18 dBFS)
-∞to -11 dBu, 8 Ω ,
unbalanced (-18 dBFS)
BNC x 2
75 Ω , unbalanced
0.5 Vp-p to 18 Vp-p, 3 kΩ , unbalanced
2.2 Vp-p, 75 Ω , unbalanced
RS-422A: D-sub 9-pin female x1
Video Control: D-sub 15-pin male x1
Control S (SIRCS): Stereo mini jack x1
AC Power Cord
Operating Instructions
Editing Recorders / Players
DSR-1500AP
70 W
60 W
6 kg (13 lb 3 oz)
210 x 130 x 420 mm
(8 3/8 x 5 1/8 x 16 5/8 inches)
25 Hz to 5.0 MHz +1.0/-1.5 dB
20 Hz to 20 kHz ±1.0 dB
20 Hz to 14.5 kHz ±1.0 dB
More than 87 dB
Less than 0.07%
—
Composite, 1.0 Vp-p, 75 Ω ,
sync negative
—
Composite, 1.0 Vp-p, 75 Ω , sync negative
—
1.0 Vp-p, 75 Ω , sync negative
—
0.7 Vp-p, 75 Ω (100 %)
—
0.7 Vp-p, 75 Ω (100 %)
—
BNC x 2
—
BNC x 1
Conforms to Serial Digital Interface
(270 Mb/s), ITU-RBT.656
—
Conforms to SDTI (270 Mb/s),
SMPTE 305M/322M
—
IEEE1394-based
—
XLR 3-pin female x2
—
-6/-3/0/+4 dBu,
high impedance
—
BNC x 2
75 Ω , unbalanced
Video 1/2/3 (super) BNC x 3
B-Y: 0.7 Vp-p, 75 Ω (100%)
BNC x 2
BNC x 2
BNC x 2
XLR 3-pin male x2
RCA x1
-∞ to +1 dBu, 47 kΩ ,
unbalanced (-20 dBFS)
-∞to -13 dBu, 8 Ω ,
unbalanced (-20 dBFS)
RS-422A: D-sub 9-pin female x1
Control S (SIRCS): Stereo mini jack x1
*7 The optional DSBK1503 is required for the DSR-1500AP
*8 The optional DSBK-1601 is required for the DSR-1600P
*9 The optional DSBK-1602 is required for the DSR-1600P
—