Argo JP 6215CD Manual de instruções - Página 12

Procurar online ou descarregar pdf Manual de instruções para Triturador de papel Argo JP 6215CD. Argo JP 6215CD 16 páginas.

CaUtiON:

it is forbidden to place more sheets of paper then the maximum

amount indicated by the producer. if the machine will be overloaded, then please proceed

according to the information given in the "paper jam" section.

FeeDiNG CreDit CarDs Or CDs

Please check the voltage of your shredders carefully before using and then plug in

and press the switch (4).

set the operation button (5) to „i", the green light lights up and the shredder is going

to standby mode.

Place the cd/credit card into the proper entry, the machine will start automatically.

When the shredding will be completed the machine will stop automatically.

When the work has beend completed, turn the power button (4) into the (O) position

and unplug the machine.

CaUtiON:

Never attempt to shred more than one credit card/cd at a time or the

shredder will jam. Never attempt to shred BOTh paper and credit cards/cds at the same

time. doing so will damage the shredder.

mOtOr PrOteCtiON

When the Overload diode (3) light s up unplug the machine from the main power source.

allow the motor to cool down to room temperature before resuming operation.

after cooling down, the shredder is ready to re-start to work. it is crucial to avoid the

situation when the thermal fuse will work - this type of usage of the shredder is not proper

and implies machine's overwork.

CUtter OiliNG iNstrUCtiONs

To ensure proper operation and function, periodic oiling of the cutting system is required.

Failure to oil your cutting system could result in reduced sheet capacity performance,

excess noise, paper jams and possibly machine failure. Oil your cutters every 5th or 6th

time you empty the basket, if excess squeaking and rubbing noise is coming from the

machine or if the shredders sheet capacity has diminished.

squeeze the lubricant across the full width of the cutters. insert paper

into sensor to activate the cutting system forward for 3 seconds. Then

press „r" to make shredder reverse for 3 seconds. alternate between for-

ward and reverse at least three times or until all paper clears the cutters.