Sony SLT-A55L Manual de serviço - Página 12

Procurar online ou descarregar pdf Manual de serviço para Câmara digital Sony SLT-A55L. Sony SLT-A55L 30 páginas. Interchangeable lens digital camera/zoom lens kit

Imprimir página

NOTE FOR REPAIR

• Make sure that the flat cable and flexible board are not cracked or

bent at the terminal.

Do not insert the cable insufficiently nor crookedly.

• When remove a connector, do not pull at wire of connector. It is

possible that a wire is snapped.

• When installing a connector, do not press down at wire of connector.

It is possible that a wire is snapped.

• Do not apply excessive load to the gilded flexible board.

DISCHARGING OF THE CHARGING CAPACITOR

The charging capacitor is charged up to the maximum 330 V

potential.

There is a danger of electric shock by this high voltage when the

capacitor is handled by hand. The electric shock is caused by the

charged voltage which is kept without discharging when the main

power of the unit is simply turned off. Therefore, the remaining

voltage must be discharged as described below.

Preparing the Short Jig

To preparing the short jig, a small clip is attached to each end of

a resistor of 1 kΩ /1 W (1-215-869-11).

Wrap insulating tape fully around the leads of the resistor to

prevent electrical shock.

Wrap insulating tape.

SUBSIDIARY MATERIALS

G: Grease

G-15 (J-6082-619-A)

G-85 (J-6082-626-A)

G-116 (J-6082-628-A)

SLT-A33/A33L/A33Y/A55/A55V/A55L/A55VL/A55VY_L2

– ENGLISH –

Cut and remove the part of gilt

which comes off at the point.

(Be careful that some

pieces of gilt may be left inside)

Note:

High-voltage cautions

Discharging the Capacitor

Short-circuit between the two points with the

short jig about 10 seconds.

To avoid the spark with the metal plate,

wrap the short jig with the insulation tape.

ST-233 Complete Board

R:1 kΩ/1 W

(Part code: 1-215-869-11)

2-2

– JAPANESE –

Note:

ST-233

R:1 kΩ/1 W

(

: 1-215-869-11)