DIGITEN WTC100 Manual do utilizador - Página 4
Procurar online ou descarregar pdf Manual do utilizador para Termostato DIGITEN WTC100. DIGITEN WTC100 9 páginas.
Também para DIGITEN WTC100: Manual do utilizador (8 páginas), Manual do utilizador (12 páginas)
Imprimir página
Measure temp Resolution
Control Precision
High and low temperature
alarm
Remote
control
frequency
Temperature probe
Put in or replace the Battery
1.2 AAA size batteries are needed for the remote. Make sure they are put in
right direction
2.When the low battery
Pair/remove with the remote
In generally, we
have already
connect controller, please repair according to the method below:
1, Press and hold
then press
M
button
2, Press and hold
quickly
before
you repair the remote, please repeat the step 1.
Note：
A remote can control multiple
Change the temperature unit
Press the
button for 3 seconds to switch the temperature unit.
Set the temperature value RUN>STOP, the controller is in cooling mode, and
the LCD displays the COOLING symbol
1.1
When
the
RUN value, the cooling operation
displays
,
CURRENT value drop to the STOP value, the cooling operation stops, and the
LCD displays
1.2 When the CURRENT temperature value is less than the RUN value, the
±0.1°C /°F
±1°C /°F
0-80°C
refresh
20 Seconds
Built in remote
warning appears, please change batteries.
paired the remote it come with. If the remote can't
button until the LED flashes, release the button,
on the remote control to pair the receiver.
button, the LED flashes 5 times, then flash 2 times
release the button. All remotes will be unpaired. If
Cooling mode
CURRENT
and the green light on the receiver is on. When the
. The green light on the receiver is off.
Receiver
NTC probe
receivers.
temperature value is higher than the
starts, the relay outputs, the LCD
with
2m/6ft