DIGITEN WTC200 Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Termostato DIGITEN WTC200. DIGITEN WTC200 9 páginas.
Também para DIGITEN WTC200: Manual do utilizador (8 páginas), Manual do utilizador (12 páginas)
Imprimir página
1. Press and hold the SET button until the corresponding value flashes. At the
same time, the
to change the number. Short press SET button to set next valve, or
long press the SET button to exit and save. use this method to set the RUN
/STOP /Delay/ HIGH /LOW value respectively. Or after setting all the
parameters, press and hold the SET button to exit and save. When no
operation time is greater than 30 seconds in the setting state, the exit setting
mode is not saved.
NOTE, in the setting state, long press the UP or DOWN button to continuously
to change the setting value
2. Example
In cooling mode, you want to keep room temperature at 77F，High alarm at
88F, Low alarm at 70F
Long press SET button until the display appears on
1)
setting value flash.
Press
2)
Short press SET button to set High and Low value.
3)
Long press SET to save and exit.
4)
Restore factory settings
In the case of POWER OFF, press and hold the SET button to power on at the
same time. After a long beep, all values are restored to the factory settings.
efault settings
D
Setting
Function
Temp unit
Temperature unit
Run
Run temperature value
Stop
Stop temperature value
High
High alarm value
Low
Low alarm value
Delay
Delay protecting time
is displayed on the LCD. Press the
or
set the RUN at 77F, STOP is 75F.
or
Setting range
C/F
0-70C
32-158
0-70C
32-158F
0-70C
32-158F
0-70C
32-158F
0-10 minutes
button
，and the
Default value
F
20C
68F
28C
82F
70C
158F
0C
32F
0