Sony XCI-V100C Manual técnico - Página 9

Procurar online ou descarregar pdf Manual técnico para Câmara digital Sony XCI-V100C. Sony XCI-V100C 23 páginas. Intelligent

Imprimir página

Connecting the Camera Cable

Connect the camera cable to the DC IN connector.

Also, if needed, connect the LAN cable to the LAN

connector, the monitor cable to the MONITOR

connector, the serial cable to the SERIAL connector, the

DIGITAL I/O cable to the DIGITAL I/O connector, and

the USB mouse/keyboard to one of the USB connectors

respectively. When you connect the monitor cable or

DIGITAL I/O cable, plug the cable connector into the

monitor connector or DIGITAL I/O connector until they

snap into place, holding them.

Then tighten the fixing screws placed on both sides of

the cable connector.

7 8

90qaqs

1 Monitor cable

2 USB cable

3 LAN cable

4 DIGITAL I/O cable

5 Camera cable

6 Serial cable

Connect the other end of 5 to the power supply.

Also, if needed, connect 1 to the monitor, 3 to the host

device, 4 to the DIGITAL I/O control device, and 6 to

the camera control device.

Note

Looseness of the fixing screws may cause poor

connection and damage the camera module or cables.

Fasten the fixing screws.

Using a Tripod

Use a tripod screw with a protrusion

the installation surface, as follows, and tighten it, using

a screwdriver.

: 4.3 mm to 5 mm (0.17 inches to 0.20 inches)

7 MONITOR connector

8 Hi-speed USB connector

9 LAN connector

0 DIGITAL I/O connector

qa SERIAL connector

qs DC IN connector

extending from

Attaching the Fall-Prevention Wire

Rope

Warning

• If you want to install the camera at a height such as on

a ceiling, entrust the installation to an experienced

contractor or installer.

• If you install the camera at a height, ensure that the

installation location and its material are strong enough to

support the weight, and then install the camera securely.

Insufficient support may cause the camera to fall,

resulting in damage to the camera and severe injuries.

• To prevent the camera from falling, be sure to attach

the supplied wire rope.

• If you install the camera at a height, check

periodically, at least once a year, to ensure that the

connection has not loosened. If conditions warrant,

perform this periodic check more frequently.

Attach the fall-prevention wire rope (supplied) to

the camera module, using the supplied screw.

Attach the other end of the fall-prevention wire

rope to a junction box, etc. (screw not supplied)

Notes

• The fall-prevention wire rope is very important for fall

prevention. Perform the procedure correctly.

• Use the screws supplied with the XCI-SX100/

SX100C/V100/V100C. Using screws other than those

supplied may cause damage inside the camera

module.

Screw

(supplied)