Cisco ASA 5515-X Manual de início rápido - Página 7

Procurar online ou descarregar pdf Manual de início rápido para Hardware de rede Cisco ASA 5515-X. Cisco ASA 5515-X 15 páginas. Threat defense reimage guide
Também para Cisco ASA 5515-X: Manual de instruções de instalação (13 páginas), Manual de início rápido (13 páginas), Manual de configuração fácil (11 páginas), Manual do software (37 páginas)

Imprimir página
Cisco ASA 5515-X Manual de início rápido
Cisco ASA 5512-X, ASA 5515-X, ASA 5525-X, ASA 5545-X, and ASA 5555-X Quick Start Guide
Management 0/0
192.168.1.2
(FirePOWER management)
a.
Cable Management 0/0 (for the ASA FirePOWER module) directly to one of: GigabitEthernet 0/1 through GigabitEthernet
0/5 (through 0/7 for the ASA 5525-X, 5545-X, and 5555-X).
Note:
You can connect inside and management on the same network because the management interface acts like a separate
device that belongs only to the ASA FirePOWER module.
b.
Cable your computer to one of: GigabitEthernet 0/1 through GigabitEthernet 0/5 (through 0/7 for the ASA 5525-X, 5545-X,
and 5555-X).
c.
Cable GigabitEthernet 0/0 (outside) to your WAN device, for example, your cable modem.
Note:
If the cable modem supplies an outside IP address that is on 192.168.1.0/24 or 192.168.10.0/24, then you must change
the ASA configuration to use a different IP address. Interface IP addresses, HTTPS (ASDM) access, and DHCP server settings
can all be changed using the Startup Wizard. If you change the IP address to which you are connected to ASDM, you will be
disconnected when you finish the wizard. You must reconnect to the new IP address.
ASA 9.6 and Earlier
The following figure shows the suggested network deployment for the ASA 5500-X with the ASA FirePOWER module:
Management PC
Cisco ASA 5512-X, ASA 5515-X, ASA 5525-X, ASA 5545-X, and ASA 5555-X Quick Start Guide
Management Computer
DHCP from inside: 192.168.1.x
Module Default Gateway
Layer 2
Switch
inside
GigabitEthernet 0/1
192.168.1.1
Management 0/0
No ASA IP address
Module IP address: 192.168.1.2
4. Modify the Initial Configuration for the ASA FirePOWER Module (Optional)
GigabitEthernet 0/1-0/5 Bridge Group
inside, 192.168.1.1
GigabitEthernet 0/0
outside, DHCP from Modem
WAN Modem
ASA
outside
GigabitEthernet 0/0
Module
Internet
Internet
7