Sony PS-HX500 Manual de serviço - Página 3

Procurar online ou descarregar pdf Manual de serviço para Sistema estéreo Sony PS-HX500. Sony PS-HX500 26 páginas. Stereo turntable system
Também para Sony PS-HX500: Manual de Instruções (28 páginas)

Imprimir página

The SERVICING NOTES contains important information for servicing. Be sure to read this section before repairing the unit.

UNLEADED SOLDER

Boards requiring use of unleaded solder are printed with the lead-

free mark (LF) indicating the solder contains no lead.

(Caution: Some printed circuit boards may not come printed with

the lead free mark due to their particular size)

: LEAD FREE MARK

Unleaded solder has the following characteristics.

•

Unleaded solder melts at a temperature about 40 °C higher

than ordinary solder.

Ordinary soldering irons can be used but the iron tip has to be

applied to the solder joint for a slightly longer time.

Soldering irons using a temperature regulator should be set to

about 350 °C.

Caution: The printed pattern (copper foil) may peel away if

the heated tip is applied for too long, so be careful!

•

Strong viscosity

Unleaded solder is more viscous (sticky, less prone to ﬂ ow)

than ordinary solder so use caution not to let solder bridges

occur such as on IC pins, etc.

•

Usable with ordinary solder

It is best to use only unleaded solder but unleaded solder may

also be added to ordinary solder.

DESTINATION ABBREVIATIONS

The following abbreviations for model destinations are used in this

service manual.

• Abbreviation

CND : Canadian model

MODEL IDENTIFICATION

Distinguish by Part No. and Destination code of model number

label stuck on the rear side of a main unit.

– Rear Panel –

MODEL NUMBER LABEL

Part No.

Destination

US and Canadian models

AEP model

UK model

SECTION 1

SERVICING NOTES

Destination code

Destination

Part No.

code

UC2

4-585-313-0[]

4-585-313-1[]

CEL

4-585-313-2[]

CEK

NOTE OF REPAIRING THE BOARDS

When the board installed by this unit is defective, replace the com-

plete mounted board. Individual electrical parts that mounted on

the each boards cannot be replaced.

NOTE IN THE CASE OF THE REVERSING THE MAIN

UNIT

Before reversing the main unit, please do the following measure

always. There is a possibility of damage if you did not the follow-

ing measure.

•

Tone arm lock

•

Remove the platter

Platter

PS-HX500

Tone arm lock