Cisco ASA 5585-X Manual de manutenção - Página 24
Procurar online ou descarregar pdf Manual de manutenção para Hardware de rede Cisco ASA 5585-X. Cisco ASA 5585-X 44 páginas. Maintenance and upgrade procedures
Também para Cisco ASA 5585-X: Manual de início rápido (40 páginas), Manual de início rápido (6 páginas)
Imprimir página
Removing and Installing the Power Supply Module
Check the PS0 and PS1 indicators on the front panel to make sure they are green. On the back panel of
Step 15
the appliance, make sure the IN OK and the FAN OK indicators are green and the OUT FAIL indicator
is off (see
Figure 4-20
1
Removing the DC Power Supply Module
Use the following tools and parts to disconnect the DC power supply module:
•
•
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003.
Warning
This unit is intended for installation in restricted-access areas. A restricted-access area can be
accessed only through the use of a special tool, lock and key, or other means of security. Statement
1017
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
Warning
installation. Install only in accordance with national and local wiring regulations. Statement 1045
Hazardous voltage or energy may be present on DC power terminals. Always replace cover when
Warning
terminals are not in service. Be sure uninsulated conductors are not accessible when cover is in
place. Statement 1075
Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide
4-24
Figure 4-20
and
Table 4-4 on page
PS0 and PS1
1
Power supply module (PS0)
5/16-inch nut-driver
M4 nut-driver
4-17).
1150W DC
2
Power supply module (PS1)
Chapter 4
Maintenance and Upgrade Procedures
2
1150W DC
OL-22567-02