Cisco ASR 9000 Series Manual de configuração - Página 37
Procurar online ou descarregar pdf Manual de configuração para Hardware de rede Cisco ASR 9000 Series. Cisco ASR 9000 Series 46 páginas. Line card
Também para Cisco ASR 9000 Series: Configuração das definições de rede (26 páginas), Manual de configuração (50 páginas), Manual (24 páginas), Configuração (46 páginas), Manual (44 páginas), Manual de referência rápida (7 páginas)
Imprimir página
Configuring Clear Channel T3/E3 and Channelized T3 and T1/E1 Controllers on the Cisco ASR 9000 Series Router
Command or Action
Step 11
bert [t1 | e1] interface-path-id [channel-group
channel-group-number] stop
Example:
RP/0/RSP0/CPU0:router# bert t1 0/3/0/0/0 stop
Step 12
show controllers [t1 | e1] interface-path-id
Example:
RP/0/RSP0/CPU0:router# show controllers t3
0/3/0/0
What to Do Next
Configure the serial interfaces that are associate with the controllers you tested, as described in the
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
Configuring Link Noise Monitoring on a T1 or E1 Channel
This section describes how to configure Link Noise Monitoring (LNM) on a T1 or E1 channel on the
Cisco ASR 9000 Series Router.
Prerequisites
Before you configure LNM on the Cisco ASR 9000 Series Router, be sure that these requirements are
met:
•
•
•
Restrictions
Before you configure LNM on the Cisco ASR 9000 Series Router, consider these restrictions:
•
•
•
SUMMARY STEPS
1.
OL-32684-01
A 2-Port Channelized OC-12c/DS0 SPA is installed.
The 2-Port Channelized OC-12/DS0 SPA is configured as a channelized T3 controller running in T1
or E1 mode, as described in the
The T1 or E1 controller is configured as a single channel supporting the full 24 or 31 DS0 time slots,
as described in the
"Configuring a T1 Controller" section on page 466
Controller" section on page
The lnm major-warning and lnm remove commands are mutually exclusive. You can only
configure one of these LNM functions on a controller.
The lnm minor-warning command can be configured with the lnm major-warning or lnm remove
commands on a controller.
When the lnm remove command is configured, links in an MLPPP bundle are removed only up to
the threshold set by the ppp multilink minimum-active links command.
configure
Cisco ASR 9000 Aggregation Services Router Interface and Hardware Component Configuration Guide
How to Configure Clear Channel T3/E3 Controllers and Channelized T1/E1 Controllers
Purpose
Stops the configured BERT test on the specified channel
group.
Displays the results of the configured BERT.
"Configuring a Channelized T3 Controller" section on page
470. LNM is not supported on a fractional T1 or E1 link.
module later in this document.
or
"Configuring an E1
461.
481