Cisco ASR 9000 Series Manual de referência rápida - Página 3
Procurar online ou descarregar pdf Manual de referência rápida para Hardware de rede Cisco ASR 9000 Series. Cisco ASR 9000 Series 7 páginas. Line card
Também para Cisco ASR 9000 Series: Configuração das definições de rede (26 páginas), Manual de configuração (46 páginas), Manual de configuração (50 páginas), Manual (24 páginas), Configuração (46 páginas), Manual (44 páginas)
Imprimir página
Cisco ASR 9000 Series
Line Card
This procedure explains installing the line
card in the horizontal position.
To install the line card in the vertical
position, follow the same steps but
hold the card vertically.
Caution!
.
For convenience and safety purposes,
.
two persons should handle the line card.
Never carry the line card by holding it by
the ejector levers or put pressure on the
.
captive screws.
To avoid damage, place the line card
horizontally on a flat antistatic surface.
The outer packaging box contains an
antistatic pink roller foam that can be used
.
for this purpose.
Retain the dust caps on the line card
throughout the installation procedure.
Also, use dust caps on unused ports in the
line card.
© 2020 Cisco Systems, Inc. All rights reserved.
Attach an antistatic wrist strap to your
1
wrist and to the ESD socket of the
chassis, or to a bare metal surface on
the chassis or frame.
Ensure to verify the effectiveness of
ESD wrist strap before handling the
hardware.
ESD socket
Antistatic
wrist band
Pivot the ejector levers to seat the
4
card into the backplane connector.
Ejector lever (closed)
Installing the Line Card
Open the ejector levers on either
2
side of the line card.
Ejector lever (open)
Tighten the captive screws on either
5
side of the line card to a torque of
+ -
10 1 in-lb.
Captive screws
Carry the line card and slide the card
3
into the slot to connect with the
backplane connector. Start with the
lowest numbered line card slot.
Captive screws
Ejector lever
Repeat Step 2 through Step 5 to
6
install another line card.
To uninstall a line card, perform the steps in
the reverse order.
For manual OIR (online insertion and removal)
of cards, disengage the line card from the
backplane connector, and partially pull out
the line card. Reseat the card to
establish the connection again.
3