ACU-RITE 01190 Manual de instruções - Página 2

Procurar online ou descarregar pdf Manual de instruções para Acessórios ACU-RITE 01190. ACU-RITE 01190 4 páginas. Water detector

Imprimir página
SETUP
Water Detector Setup
Using the Water Detector
The Water Detector works as a stand-alone unit which can be placed where leaks may occur and
has an audible alert when liquid is detected. It may also be used with a Wireless Receiver (sold
separately) which can be placed in a living area, ensuring that you hear the alert.
Placement Guidelines
Water will naturally flow towards the low point of the area that is beings monitored. For the best
results, place Water Detector in an area where water is most likely to collect.
You may place the Water Detector upright in the desired location (Figure A), or mount the base with
the wired sensor placed on ground level (Figure B).
NOTE: The sensor is water-resistant and is designed to detect the presence of liquid/leaks. However,
to extend it's life, place the Water Detector in an area where it will not remain submerged in liquid.
FIGURE A
ON OFF
WATER DE TEC TOR
Specifications
POWER
WIRELESS RANGE
CORD
DATA REPORTING
SOUND INTENSITY
1
Remove Battery
Compartment
2
A-B-C Switch
Set to match receiver
(if applicable).
A B C
3
Install Batteries
2 AA batteries
2 x AA alkaline batteries
330 ft / 100 m (depending on home construction materials)
2.5 ft (.6m) length; Water-resistant
1 second updates once water is detected
85 dB at 3.3 ft (1 meter)
1
Remove the battery compartment
cover.
2
If purchased with a Wireless
Receiver, set the A-B-C switch
located inside the battery
compartment.
You must select the same letter
choices for both the detector and
the receiver in order for the units to
synchronize.
3
Insert 2 x AA batteries into the
battery compartment as shown.
Follow the polarity (+/-) diagram in
the battery compartment.
4
Replace the battery cover.
FIGURE B
ON OFF