Cisco C7200-I - Input/Output Controller - Control Processor Manual do utilizador - Página 3
Procurar online ou descarregar pdf Manual do utilizador para Hardware de rede Cisco C7200-I - Input/Output Controller - Control Processor. Cisco C7200-I - Input/Output Controller - Control Processor 16 páginas. Input/output controllers
Imprimir página
Cisco 7200-I/O-GE+E and Cisco 7200-I/O-2FE/E Input/Output Controllers
Supported Standards, MIBs, and RFCs
Standards
No new or modified standards are supported by this feature.
MIBs
No new or modified MIBs are supported by this feature.
For descriptions of supported MIBs and how to use MIBs, see the Cisco MIB web site on CCO at
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml.
RFCs
No new or modified RFCs are supported by this feature.
Configuration Tasks
See the following sections for configuration tasks for the Cisco 7200-I/O-GE+E and the
Cisco 7200-I/O-2FE/E feature. Each task in the list indicates if the task is optional or required.
•
•
•
•
For Cisco 7200 VXR routers used as router shelves in AS5800 Universal Access Servers,
Note
use the router-shelf/slot/port command format for all interface commands.
Configuring the Interface Transmission Mode
This section describes the procedure for configuring the interface transmission mode. The Fast Ethernet
and Ethernet interfaces on the Cisco 7200-I/O-2FE/E are duplex auto by default.
Command
Step 1
Router(config)# configure terminal
Step 2
Router(config-if)# interface fastethernet 0/0
Step 3
Router(config-if)# duplex full
1.
Use the interface fastethernet router-shelf/slot/port command for a Cisco 7200 VXR used as a router shelf in an AS5800 Universal Access
Server.
Configuring the Interface Transmission Mode (Optional)
Configuring Interface Speed (Optional)
Configuring the Ethernet, Fast Ethernet, and Gigabit Ethernet Interfaces (Required)
Verifying the Configuration (Optional)
Purpose
Enters configuration mode and specifies that the
console terminal is the source of the configuration
subcommands.
1
Selects the Fast Ethernet interface to configure.
Changes the Fast Ethernet interface port
transmission mode to full duplex from
autonegotiation.
Supported Standards, MIBs, and RFCs
12.1(5)T and 12.2(14) S
3