Cisco Firepower 4150 Manual

Procurar online ou descarregar pdf Manual para Hardware de rede Cisco Firepower 4150. Cisco Firepower 4150 26 páginas. Rack-mount and ground the chassis
Também para Cisco Firepower 4150: Manual de manutenção e atualização (20 páginas), Manual (36 páginas), Manual (8 páginas), Manual (42 páginas), Começar a trabalhar (42 páginas)

Imprimir página

Installation, Maintenance, and Upgrade

•

Install, Remove, and Replace the Network Module

Hot Swapping

Caution

Note

Install, Remove, and Replace the Network Module, on page 1

Remove and Replace the Fan Module, on page 4

Remove and Replace the SSD, on page 6

Remove and Replace the Power Supply Module, on page 9

Connect the DC Power Supply Module, on page 13

Secure the Power Cord on the AC Power Supply Module, on page 19

Install the FIPS Opacity Shield, on page 22

Starting with FXOS 2.3.1, the Firepower 10-Gb and 40-Gb network modules (without hardware bypass

support) support hot swapping, but you must hot swap with an identical network module, that is, a network

module with the same PID. See

network module offline using the appropriate CLI commands before removing the network module from

the chassis so that all network module configuration is saved. See the "Taking a Network Module Offline

or Online" topic in the Security Module/Engine Management chapter in the

Chassis Manager Configuration

We do not recommend that you remove the network module without bringing it properly offline using

the appropriate CLI commands.

You must have ROMMON 1.0.10 or later on the Supervisor to support hot swapping. For the ROMMON

upgrade procedure, see the "Firmware Upgrade" topic in the Image Management chapter in the

FXOS Firepower Chassis Manager Configuration Guide

To remove and replace the network modules that do not currently support hot swapping, power off the

chassis, replace the network module, and then power the chassis back on.

Acknowledgment is necessary if you decommission and physically remove a network module and do

not replace it, or if you replace it with another PID. See the "Acknowledging a Security Module/Engine"

Product ID Numbers

for the network module PIDs. You must bring the

Guide.

for your software version.

Installation, Maintenance, and Upgrade

Cisco FXOS Firepower

Cisco