Cisco Gigabit Switch Router Cisco 12012 Manual de instruções de instalação - Página 6

Procurar online ou descarregar pdf Manual de instruções de instalação para Hardware de rede Cisco Gigabit Switch Router Cisco 12012. Cisco Gigabit Switch Router Cisco 12012 14 páginas. Gigabit switch router cablemanagement kit
Também para Cisco Gigabit Switch Router Cisco 12012: Manual de instruções de substituição (34 páginas), Manual de instruções de substituição (6 páginas), Ficha de dados (9 páginas), Manual de instruções de substituição (20 páginas)

Removing and Replacing the Cable-Management System

This section provides the procedures for removing and replacing a horizontal cable-management

tray or a vertical cable-management bracket.

Removing a Horizontal Cable-Management Tray

The horizontal cable-management tray is mounted above the upper card cage and spans the width of

the frame. It is secured to the frame with four screws. Perform the following procedure to remove

the horizontal cable-management tray:

Step 1

Step 2

Step 3

Step 4

Step 5

Repeat Step 3 through Step 5 for the rest of the vertical cable-management brackets on the line cards.

Step 6

Step 7

Step 8

6 Cisco 12012 Gigabit Switch Router Cable- Management Kit Installation Instructions

Attach an antistatic wrist strap to yourself and to one of the two ESD connection sockets

located on the front edges of the upper card cage or to bare metal on the frame.

Proceeding from left to right, identify each line card and write down the following

information:

•

The slot number and type of line card.

•

The interface cable connections to the line card ports. You will need to reconnect the

interface cables to the same line card ports.

Proceeding from left to right in the upper card cage, select a line card. Starting with the

bottom port on the line card and working up (for cards with multiple ports only),

disconnect the network interface cable from the line card ports. Do not remove the cables

from the vertical cable-management bracket. (Refer to Figure 2.)

Loosen the captive screws at the top and bottom of the vertical cable-management

bracket. (Refer to Figure 2.)

Remove the vertical cable-management bracket from the line card and remove the

attached cables from the horizontal cable-management tray. Position the vertical

cable-management bracket out of the way of the horizontal cable-management tray.

Remove the four screws at the lower edge the horizontal cable-management tray. (Refer

to Figure 3.)

Pivot the bottom of the tray out, away from the frame, to disengage three horizontal

cable-management tray tabs (at the top of the tray) from the slots in the frame.

Remove the horizontal cable-management tray from the frame and set it aside.