Digitrax DH163A0 Manual - Página 2

Procurar online ou descarregar pdf Manual para Conversor de multimédia Digitrax DH163A0. Digitrax DH163A0 8 páginas. Mobile decoder circuit board replacement 1.5 amp/2 amp peak 6 fx3 functions, 0.5 amp

Imprimir página

Parts List

1 DH163A0 Decoder

Installation Information

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions.

Installation Instructions - Atlas GP-3 3 8 Locomotive

1. Carefully remove the locomotive's

shell from the frame. Notice the ori-

entation of the circuit board inside

so that you can install the decoder

in the same orientation. (Figure 1)

2. Slide the circuit board backward

and lift to release it from the frame

clips.

3. Slide the board to one side of the

frame to remove the black plastic

wire retainers that connect the wires

to the board. (Figure 2) Slide the

board to the other side to remove

the remaining wire retainers. There

are 4 retainers on each end and 2 on

the side for the motor connection.

4. The DH163A0 decoder is installed

in the same orientation as the

factory board. There is yellow tape

on the bottom side of the decoder

for insulation. Connect the wires to

the decoder in the same configura-

tion as the factory board using the

wire retainers. (Figure 3) Slide the

decoder over the frame clips to hold

it in place on the frame.

5. You are now ready to run your loco-

motive. The DH163A0 is factory

programmed to address 03. you can

easily customize the address and

other features. See the following

sections and the Digitrax Decoder

Manual for more information.

D D

C C

igitrax

ommand

Run Your Trains, Not Your Track!

www.digitrax.com

C C

ontrol

1 Instruction sheet

Figure 1. Remove shell

decoder

frame clips-

slide board to back and

lift off clips

Figure 2. Remove decoder

Remove plastic wire retainers

(4 each end, 2 on side)

Figure 3. Install decoder

Replace plastic wire retainers

(4 each end, 2 on side)

Slide decoder to side of

frame