argon audio FENRIS Início rápido - Página 2

Procurar online ou descarregar pdf Início rápido para Altifalantes argon audio FENRIS. argon audio FENRIS 2 páginas.

Imprimir página
Quick start
1.
Connect the speakers using the included speaker cable.
2.
Connect the power cord into an electric outlet and into the back
of the left speaker (which has the amplifier). The LED light on
the loudspeaker will turn on.
3.
To pair your Bluetooth device, turn on the speakers and press
and hold 'BT' on your remote for about 3 seconds, until the LED
starts blinking. Your speakers are now in pairing mode. Activate
Bluetooth on your playback device and scan for devices. Your
speaker will show up as "Argon Audio FENRIS". Press "pair" and
you're connected. The LED light on the speaker will change to
solid blue. You're now ready to start listening to music!
4.
Besides Bluetooth, your FENRIS speakers have four more inputs:
TV ARC, D1, AUX and Phono. FENRIS will automatically switch
between the inputs, but you can also use the included remote
control to select your wished input.
5.
When using the TV ARC input, you might need to set the digital
sound output on your TV to PCM. Consult your TV manual to see
how.
6.
When connecting a turntable to the Phono input on the FENRIS
speaker, remember to also connect the ground wire from the
turntable to the metal GND screw (if applicable).
7.
If you have an active subwoofer, connect it to the FENRIS
speaker's Pre-out, using an RCA cable and then connect the
cable to your subwoofer.
w w w . a r g o n a u d i o . c o m
FENRIS active quick start
8.
We recommend a running-in time of your FENRIS speakers of
approximately 15-20 hours at normal listening level before you
decide on the final positioning of the speakers.
Basic operating
1.
When the FENRIS speakers receive input from any connected
source (except Phono), they will automatically power on (if
powered off) and switch to the right input. This is called Auto
Power Up. Note: this will not happen if the speakers are already
powered on and playing from another source.
2.
You can disable Auto Power Up (APU) if needed: simply press
and hold the power button on remote control for 5 seconds
while the speakers are on. The speakers will now power off
with APU disabled. This will also disable automatic power off,
meaning you need to turn off your speakers manually.
3.
To enable APU again, simply press and hold the power button
for 5 seconds again when the speaker is powered off.
4.
You can always press and hold the 'BT' button to reset all
Bluetooth connections. Please note that Bluetooth pairing is only
available when the Bluetooth-input is selected.
5.
To enable dimming of the LED on the front of the speaker,
power on the speaker and hold the D1 button on the remote for
5 seconds. The LED will now turn off after 5 seconds after
switching inputs. To disable again, press and hold D1 for 5
seconds again.