Digitrax DN166I2B Folha de instruções - Página 2

Procurar online ou descarregar pdf Folha de instruções para Brinquedo Digitrax DN166I2B. Digitrax DN166I2B 8 páginas.

Imprimir página

Parts List

1 DN166I2B Mobile Decoder

Installation Information

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions. CAUTION: Programming and layout track must not exceed

16V when using this decoder.

Installation Instructions

Carefully remove the locomo-

tive's shell from the frame by

inserting two toothpicks under

the unit's ladders as shown.

Grasp the frame and toothpicks

with one hand and the locomo-

tive's shell with the other hand

and carefully separate the two.

Once the shell is off, remove the

existing light board by removing

the two screws located on the

diagonal corners of the board

and unsoldering the motor and

light connections. Note: It

is important to make sure the

motor and LED are electricaly

isolated from the frame. For full

details visit www.digitrax.

com/funit

Take the new DN166I2B decod-

er and feed the motor leads up

through the holes as show in

Figure 4.

Solder headlight leads and

motor leads to the new decoder

board as shown. The final step is

to secure the decoder with the original screws. Note: the locomotive's frame

halves may have to be loosened slightly to achieve proper alignment.

CAUTION: When attaching headlight and motor wires, be very careful

that the wires you attach do not come into contact with any other pads

or components on the board where they might create a short circuit.

Figure 1: Insert

toothpicks as

shown

Unsolder light and

motor connections

Figure 2: Unsolder the wires

from the light board.

— 2 —

1 Instruction Sheet

Toothpicks

inserted under

center of body