argon audio TT Início rápido - Página 2

Procurar online ou descarregar pdf Início rápido para Gira-discos argon audio TT. argon audio TT 2 páginas.
Também para argon audio TT: Manual (9 páginas)

Imprimir página

Quick start - Set-up

Install the Lid carefully over the hinge prongs.

Install the drive belt over the inner ring under the platter and

make sure it won't fall off during the setup. Place the platter

through the turntable spindle,

then rotate the platter until you

see the drive motor pulley

through the window at the top

left corner. Carefully grab the

drive belt and put it around the

slot of motor pulley.

Connect the power adapter to

the turntable and power on the turntable.

Set the Motor Start/Stop switch to the Start position to see if

the platter motor spins. If the platter does not spin, try the

steps listed above again.

Place the slipmat on the platter.

For cartridge down force adjustment use the counterweight

supplied in the box. Gently push and turn the counterweight

onto the arm tube stub. Lower the arm lift and position the

cartridge in the space between arm rest and platter.

Carefully rotate the counterweight until the arm tube

balances out. The arm should return to the balanced

position if it is moved up or down. This adjustment must be

done carefully. Do not forget to remove the cartridge

protection cap if fitted.

Notice: You can find a full User Manual in PDF format for this

product on www.argonaudio.com

w w w . a r g o n a u d i o . c o m

Once the tonearm is correctly balanced return it to its rest.

Hold the counterweight without moving it, and gently rotate the

down force scale ring until the zero is in line with black line on

the rear of the tonearm. Check whether the arm still balances

out.

Rotate the counterweight counter clockwise (seen from the

front) to adjust the down force. One mark on the scale

represents 0.05g of down force. The recommended down

force for the factory fitted cartridge is 3.0±0.5g.

For connecting the TT to an amplifier: This turntable uses a

moving magnetic cartridge and has a RIAA amplifier built in. If

you are using a separate phono input or phono amplifier, set the

RIAA ON/OFF Switch on the back to OFF mode. For

connection all other inputs (AUX, Video, CD etc.) set the

RIAA Switch to ON.

T T Q u i c k s t a r t