argon audio tt-2 Manual do utilizador - Página 9
Procurar online ou descarregar pdf Manual do utilizador para Gira-discos argon audio tt-2. argon audio tt-2 12 páginas.
Também para argon audio tt-2: Manual do Proprietário (12 páginas), Manual do Proprietário (12 páginas)
Imprimir página
Anti-skating force adjustment
The anti-skating force must be adjusted according to the
mass of the cartridge as follows:
Downforce
Groove in the stub (15)
10 - 15mN
1
15 - 20mN
2
20mN and bigger
3
Slip the loop of the anti-skating weight's thread over the second groove of the stub to
set the correct anti-skating force for the factory-fitted cartridge. Feed the thread
through the loop of the wire support (17).
Connection to the amplifier
The Argon Audio TT2 has a captive tonearm signal lead (14) for connection to the
amplifier. Use the Phono input (sometimes labelled gram, disc or RIAA) on your amplifier.
Make sure that the phono input offers correct matching and amplification for the type of
cartridge used. Line inputs (such as CD, Tuner, Tape or Video) are not suitable.
Take care to connect the left and right channels correctly. The right channel is usually
marked red, the left channel black or white. Check the manual supplied with your
amplifier for relevant information. The earthing wire of the tonearm lead should be
connected to the earth terminal on your amplifier (if provided).
If your amplifier does not have an input suitable for phono cartridges you will require a
separate phono amplifier stage for MM or MC cartridges such as the ARGON AUDIO
PHONO1, PRO-JECT PHONO BOX, or the NAD RIAA AMP, which is then connected
between the record player and a free line level input of the amplifier.
NOTICE. Argon Audio TT2 OPT version has build in RIAA AMP
The recommended load resistance for the factory fitted cartridge is: 47kohms/MM-
input
Mains power connection
The turntable is supplied with a power supply suitable for your country's mains supply.
Check the label before connecting to ensure compliance with the mains rating in your
house.
Connect the low voltage plug from the power supply to the socket (13) on the rear of
the record player before connecting the power supply to the mains.
Fitting the lid
Fit the lid (dust cover 10) carefully over the hinge prongs and adjust the screws (12)
until the lid stays open where you want it to without being too stiff to open or close.
Switching on and off
Pressing the power switch (20) alternately starts or stops the motor.
st
from bearing rings
nd
"
"
"
rd
"
"
"
w w w . a r g o n a u d i o . c o m
T T 2
9