Argonaut G615XLR Manual de referência - Página 3

Procurar online ou descarregar pdf Manual de referência para Equipamento marítimo Argonaut G615XLR. Argonaut G615XLR 20 páginas. Marine monitor

Getting Started and Care

Your Argonaut G615XLR monitor has been engineered for trouble-free use in the marine environment.

Please retain this reference guide for relevant installation, wiring, care information, and operation

adjustment (Button Controls).

Surface Mounting

The G615XLR monitor has been designed for an easy, secure and sealed installation. For surface mount

installations, please note the following steps:

1) Locate a suitable installation mounting surface. The surface should be flat and allow at least

enough room for the outside bezel face to fit (14.45" x 11.70" W x H). Note that the thickness of

the display is 1.35" so make sure there is enough clearance to mount in your desired

location. Make sure there is sufficient clearance behind the surface for cabling passage (.75"

minimum recommended). Rear surface space should also allow clearance to install mounting

screws from the rear; however, the display can be installed without using mounting screws, if

necessary.

2) Once mounting location is identified, carefully align the mounting template to the surface in the

exact location desired and secure lightly with tape. Mark the centers of the 4 outer corner holes.

Mark the connector clamp bracket outline and outside edge of the template. Once all holes

are marked, surface may be drilled and cut accordingly.

3) Monitor can now be seated against the surface. In some installations, a bead of marine caulking

may be desired to help prevent any water intrusion to the mounting surface openings. This bead

of caulking/adhesive can be placed upon the outer edge of the back cover and may also be

sufficient to secure the monitor in place without screwing into the enclosure from behind the

surface. Take care not to allow sealant to penetrate the gap between the front bezel and rear cover

as this may prevent opening the monitor if service is ever needed. Another approach is to lay down

a thin layer of weather stripping flush to the monitor edge. This strip can be sealed at the edges

with caulking. In general, after positioning/sealing is complete, screw monitor down to surface

(Note: screw type is M4 x 12 stainless steel machine thread and 4 screws are provided). A

different length screw may be required depending on bulkhead thickness. In all installations,

where water contact can occur with the display, caulking sealant should be placed around the

screw and connector clamp bracket openings. Once secured to the surface, take care not to over

tighten mounting screws.