Cisco PIX 506E Manual de início rápido - Página 7

Procurar online ou descarregar pdf Manual de início rápido para Hardware de rede Cisco PIX 506E. Cisco PIX 506E 17 páginas. Chapter 3
Também para Cisco PIX 506E: Manual de início rápido (18 páginas), Manual do utilizador (8 páginas)

Imprimir página

PDM Version 2.0 and higher releases include a Startup Wizard for initial configuration. Follow these steps

to use the Startup Wizard:

If you have not already done so, use an Ethernet cable to connect your PC to the inside port

Step 1

(Ethernet 1) on the rear panel of the PIX Firewall.

Configure your PC to use DHCP (to receive an IP address automatically from the

Step 2

PIX Firewall) or assign a static IP address to your PC by selecting an address out of the

192.168.1.0 network.

The inside interface of the PIX Firewall is assigned 192.168.1.1, so choose a different

Note

IP address.

Check the ACT LED on the rear panel of the PIX Firewall (see Table 2 on page 11) to verify

Step 3

that your PC has basic connectivity to the inside port (Ethernet 1). When connectivity occurs,

the ACT LED next to the port lights up solid green.

To access the Startup Wizard, use a PC connected to the inside port and enter the URL

Step 4

https://192.168.1.1/startup.html into your browser.

Note

Remember to add the "s" to "https" or the connection fails. HTTPS (HTTP over SSL)

provides a secure connection between your browser and the PIX Firewall that you are

using PDM to configure or monitor.

Do not enter your username or password, just press Enter.

Step 5

Accept the certificates and follow the instructions in the Startup Wizard. For online help, click

Step 6

the Help button at the bottom of the Startup Wizard window.