Cisco PIX-515E Manual de início rápido - Página 31

Procurar online ou descarregar pdf Manual de início rápido para Hardware de rede Cisco PIX-515E. Cisco PIX-515E 42 páginas. Security appliance
Também para Cisco PIX-515E: Manual de início rápido (42 páginas)

Imprimir página

Figure 6

Ethernet Circuit Boards Installed in Auxiliary Assembly

Ethernet 2

Ethernet 3

If you need to install an optional circuit board, refer to the "Installing a Circuit Board

Note

in the PIX 515E" section in the Cisco PIX Security Appliance Hardware Installation

Guide.

If you have a second PIX 515E security appliance to use as a failover unit, install the failover

feature and cable as described in the "Installing Failover" section in the Cisco PIX Security

Appliance Hardware Installation Guide.

Connect the inside, outside, or perimeter network cables to the interface ports. Starting from

Step 3

the top left, the connectors are Ethernet 2, Ethernet 3, Ethernet 4, and Ethernet 5. The

maximum number of allowed interfaces is six with an unrestricted license.

Do not add a single-port circuit board in the extra slot below the four-port circuit

Note

board because the maximum number of allowed interfaces is six.

Power on the unit from the switch at the rear to start the PIX 515E security appliance. Do not

Step 4

power on the failover units until the active unit is configured.

100 Mbps

Link

FDX

FAILOVER

100 Mbps

Link

FDX

10/100 ETHERN ET 0/0

CONSO LE

Ethernet 1

Ethernet 0