Cisco 2500 Series Manual de configuração - Página 15

Procurar online ou descarregar pdf Manual de configuração para Servidor Cisco 2500 Series. Cisco 2500 Series 19 páginas. Wireless controller
Também para Cisco 2500 Series: Manual de instalação (12 páginas), Manual de implantação (23 páginas), Manual de configuração (50 páginas), Manual de iniciação (47 páginas)

Step 3

Configuring the Synchronous Serial Interfaces

The synchronous serial interfaces are configured to allow connection to WANs through a

CSU/DSU. Once the Ethernet or Token Ring port on your access server has been

configured, take the following steps to configure the serial port:

Step 1

Step 2

Step 3

Determine if you are going to enable IPX on this interface, enter the unique IPX

network number. See the appendix "Internetworking Primer" for additional

information on IPX routing:

Configure IPX on this interface? [no]: yes

IPX network number [1]: B001

Configure XNS on this interface? [no]

Enter yes to configure serial port 0:

Configuring interface Serial0:

Is this interface in use? [no]: yes

Determine what protocols you will allow on the synchronous serial interface and

enter the appropriate responses:

Configure IP unnumbered on this interface? [no]: no

IP address for this interface: 172.16.73.1

Number of bits in subnet field [8]:

Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [yes]:

AppleTalk starting cable range [2]: 3

AppleTalk ending cable range [3]: 3

AppleTalk zone name [myzone]: ZZ Serial

AppleTalk additional zone name:

Configure IPX on this interface? [no]: yes

IPX network number [2]: B000

Configure the second synchronous serial interface as follows:

Configuring interface Serial1:

Is this interface in use? [no]:

Configuring the Cisco 2500 Series Access Server 4-15

Configuring the Access Server