Cisco 2501 - Router - EN Manual de configuração - Página 11
Procurar online ou descarregar pdf Manual de configuração para Servidor Cisco 2501 - Router - EN. Cisco 2501 - Router - EN 19 páginas. Access server - chapter 4
Também para Cisco 2501 - Router - EN: Manual do utilizador (11 páginas)
Imprimir página
Interface
Ethernet0
Serial0
Serial1
Choose what protocols to support on your Ethernet or Token Ring interface. For
Step 4
IP-only installations, you can accept the default values for most of the questions.
A typical configuration using IP, IPX, and AppleTalk follows:
Configuring global parameters:
Enter host name [Router]: router
Enter the enable secret password, the enable password, and the virtual terminal
Step 5
password:
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter enable secret : shovel
The enable password is used when there is no enable secret
and when using older software and some boot images.
Enter enable password : trowel
Enter virtual terminal password: pail
Enter yes or no to accept or refuse SNMP management:
Configure SNMP Network Management? [no]:
The Simple Network Management Protocol (SNMP) is the most widely supported
open standard for network management. It provides a means to access and set
configuration and run-time parameters of routers and communication servers.
SNMP defines a set of functions that can be used to monitor and control network
elements.
Step 6
Determine if you will be using DECnet on your access server. If you are
configuring for DECnet, enter the appropriate values for your area number, node
number, and area routing:
Configure DECnet? [no]:
IP-Address
OK?
unassigned
NO
unassigned
NO
unassigned
NO
Configuring the Cisco 2500 Series Access Server 4-11
Configuring the Access Server
Method
Status
not set
up
not set
down
not set
down
Protocol
down
down
down