Cisco 7513 Series Manual de instruções de substituição - Página 14

Procurar online ou descarregar pdf Manual de instruções de substituição para Servidor Cisco 7513 Series. Cisco 7513 Series 26 páginas. Chassis replacement
Também para Cisco 7513 Series: Manual de início rápido (44 páginas), Ficha de dados (11 páginas), Manual (30 páginas), Atualização (20 páginas), Manual de instruções de substituição (19 páginas), Manual de instruções de substituição (22 páginas)

Removing the Old Card Cage and Backplane Assembly

Caution

(EMI) emissions standards in a Cisco 7513 or Cisco 7576 chassis with a single power supply, the

power supply blank must remain in the power supply bay adjacent to the power supply. (See

Figure 10.) Replace this blank in the chassis after you replace the card cage assembly. To prevent

system problems, do not mix AC-input and DC-input power supplies in the same chassis.

Figure 10

Step 5

This completes the power supply removal procedure.

Removing the Old Card Cage and Backplane Assembly

The card cage and backplane consist of one assembly that can be removed and replaced as required.

There are no wires, harnesses, or connectors. The assembly slides into and out of the chassis and

attaches to the chassis frame with four slotted captive screws. (See Figure 11.)

For this procedure, you need one large ﬂat-blade screwdriver, an antistatic bag for each removed

processor module, or several antistatic mats or pieces of antistatic foam.

Timesaver

processor modules and both power supplies. Plan this procedure so that you can minimize its effects

on your system.

14 Cisco 7513, Cisco 7513-MX, and Cisco 7576 Card Cage and Backplane Assembly Replacement Instructions

To maintain agency compliance requirements and meet electromagnetic interference

Power Supply Blank

Captive screw

Repeat Step 1 through Step 4 for a second power supply, if one is installed.

Repeat Step 3 and Step 4 for the power supply blank, if one is present.

Before you can remove the card cage and backplane assembly, you must remove all