Cisco C220 Configuração

Procurar online ou descarregar pdf Configuração para Servidor Cisco C220. Cisco C220 10 páginas.

Server Setup

This chapter provides instructions for setting up the server. It includes the following topics:

•

Connect Power Supplies and KVM Adapter

To begin, connect both power supplies on the back of your appliance. Connect the included KVM adapter to

an external monitor and keyboard, and plug into the KVM port located at the front of the server, as illustrated

in Figure 3.

If CIMC is configured, you can use a remote KVM. See

Refer to the server product documentation for detailed hardware and environmental setup information (See

Product

Network Interface Connections Setup

The SFP+ modules must be connected to the chassis before the appliance is powered on for the session in

which the configuration wizard is going to be run. However, wiring the SFP up to the network can be done

between power on and configuration.

Note

For Threat Grid Appliance (version 2.7.2 or later), only the Threat Grid M5 Appliance is supported. Refer to

the

Cisco Threat Grid M5 Appliance Hardware Installation Guide

C220 M3 Rack Server Setup

The interfaces must be properly connected and configured for the appliance to operate.

All manuals and user guides at all-guides.com

Connect Power Supplies and KVM Adapter, on page 1

Network Interface Connections Setup, on page 1

Network Interface Setup Diagram, on page 4

Firewall Rules, on page 5

Power On and Boot Up Appliance, on page 8

Documentation).

CIMC

Configuration.

for server setup instructions.

Server Setup