Cisco Nexus 7000 Series Manual de instalação

Procurar online ou descarregar pdf Manual de instalação para Servidor Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 16 páginas. Switch chassis
Também para Cisco Nexus 7000 Series: Manual de referência (2 páginas), Manual de instruções de instalação (39 páginas), Referência (34 páginas), Manual de instalação (18 páginas), Configuração (8 páginas), Manual de configuração (28 páginas), Manual de início rápido (10 páginas), Manual de início rápido (29 páginas), Manual de instruções de substituição (14 páginas), Manual de instruções de substituição (21 páginas), Manual de resolução de problemas (10 páginas)

Installing the Switch Chassis

This chapter includes the following topics:

•

Before you install the switch, you must install a standard four-post, 19-inch EIA data center rack (or a cabinet

that contains such a rack)

Bolt the rack to the concrete subfloor before moving the chassis onto it.

Note

Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor before

you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over.

If the rack has bonded construction, connect it to the earth ground. This action enables you to easily ground the switch

and its components and to ground your electrostatic discharge (ESD) wrist strap to prevent damaging discharges when

you handle ungrounded components before installing them.

Step 3

If you need access to the source power at the rack, include either AC power receptacles or a DC power interface unit

(PIU) with the amperage required by the switch that you are installing. .

If you are using DC power, be sure that the DC power supply is grounded and that there is direct access to the facility

DC power or indirect access though a power interface unit (PIU). You must connect the DC power supply to the earth

ground before you connect it to the facility DC power.

Note

Take care when connecting units to the supply circuit so that wiring is not overloaded.

Cabinet and Rack

Requirements.

Installing the Switch Chassis