Cisco SNS-3515-K9 Instalação do software - Página 32
Procurar online ou descarregar pdf Instalação do software para Servidor Cisco SNS-3515-K9. Cisco SNS-3515-K9 38 páginas.
Também para Cisco SNS-3515-K9: Manual de instalação (36 páginas)
Imprimir página
Run the Setup Program
Step 1
Reformat the USB device using FAT16 or FAT32 to free up all the space.
Step 2
Plug in the USB device to the local system and launch Fedora Media Writer.
Step 3
Click Browse from the Use existing Live CD area and select the Cisco ISE ISO file.
Step 4
(If there is only one USB device connected to the local system, it is selected automatically) Select the USB device from
the Target Device drop down.
Step 5
Click Create Live USB.
The progress bar indicates the progress of the bootable USB creation. After this process is complete, the contents of
the USB drive is available in the local system that you used to run the USB tool. There are two text files that you must
manually update before you can install Cisco ISE.
Step 6
From the USB drive, open the following text files in a text editor:
• isolinux/
• syslinux/syslinux.cfg
• EFI/BOOT/grub.cfg
Step 7
Replace the term "cdrom" in both the files.
• If you have a SNS 3415 appliance, replace the term "cdrom" with "hd:sda1" in both the files.
• If you have a SNS 3495, 3515, or 3595 appliance, replace the term "cdrom" with "hd:sdb1" in both the files.
Specifically, replace all instances of the "cdrom" string. For example, replace
ks=cdrom/ks.cfg
with
ks=hd:sdb1:/ks.cfg
Step 8
Save the files and exit.
Step 9
Safely remove the USB device from the local system.
Step 10
Plug in the bootable USB device to the Cisco ISE appliance, restart the appliance, and boot from the USB drive to
install Cisco ISE.
Run the Setup Program
This section describes the setup process to configure the ISE server.
The setup program launches an interactive command-line interface (CLI) that prompts you for the required
parameters. An administrator can use the console or a dumb terminal to configure the initial network settings
and provide the initial administrator credentials for the ISE server using the setup program. This setup process
is a one-time configuration task.
Note
If you are integrating with Active Directory (AD), it is best to use the IP and subnet addresses from a dedicated
Site created specifically for ISE. Consult with the staff in your organization responsible for AD and retrieve
the relevant IP and subnet addresses for your ISE nodes prior to installation and configuration.
Install Cisco ISE Software on Cisco SNS Appliances
32
Install Cisco ISE Software on Cisco SNS Appliances