Cisco UCS Manual do utilizador - Página 27

Procurar online ou descarregar pdf Manual do utilizador para Servidor Cisco UCS. Cisco UCS 50 páginas. C-series

Chapter 6

Installing Operating Systems

Parameter

IQN Name field

CHAP Username field

CHAP Password field

Note

When configuring iSCSI parameters in CMC, configure values for primary target only and leave the

secondary target values blank. If you configure secondary target then ESXi installation will fail.

Note

Installation of ESXi on iSCSI software targets are not supported through SCU.

Network Settings

The Network Settings allows you to enter the network configuration settings for the onboard network

adapters that are detected by the operating system during installation. These settings do not affect the

network settings for the CMC. We recommend that you set different IP addresses for the operating

system and CMC. The network interface column lists each network adapter detected by the UCS-SCU.

Your operating system may have a different name for the interface after you install the operating system.

Note

Only one of the active network should be configured, and this network interface will be ESXi

management network.

To configure the network settings, follow these steps:

Note

iSCSI Disk is always listed under Media Type. If you choose iSCSI disk for OS

installation, then you are required to enter the required input fields to discover the iSCSI

target. To discover the iSCSI target, click Get Disks button.

From the Select Disk drop-down list, select the disk on which the OS will be installed.

Description

Allows you to enter the initiator IQN name.

Required if ACL mandates connection with a

specific IQN Name.

Note

If the value is left blank an auto-generated

IQN name would be used.

Note

IQN Name might be required depending

on vendor target configuration.

Required if the target ACL enables CHAP and

mandates access via CHAP credentials.

Required if the target ACL enables CHAP and

mandates access via CHAP credentials.

Cisco UCS Server Configuration Utility, Release 5.0

ESXi Install

6-3