Cisco UCS B260 M4 Nota de instalação e manutenção - Página 19
Procurar online ou descarregar pdf Nota de instalação e manutenção para Servidor Cisco UCS B260 M4. Cisco UCS B260 M4 46 páginas. Blade server
Também para Cisco UCS B260 M4: Nota de instalação e manutenção (50 páginas)
Imprimir página
Installing a Blade Server
Step 2
Grasp the front of the blade module and place your other hand under the blade to support it.
Figure 6: Positioning a UCS B260 M4 Blade Module in the Chassis
Step 3
Open the ejector levers in the front of the blade module.
Step 4
Gently slide the blade into the blade slot opening until you cannot push it any farther.
Step 5
Press the ejector levers so that they latch with the edge of the chassis and press the blade module all the way
in.
Step 6
Tighten the captive screw on the front of the blade to no more than 3 in-lbs. Tightening with bare fingers will
prevent stripped or damaged captive screws.
Step 7
Attach the UCS Scalability Terminator or UCS Scalability Connector to the blade module(s) as follows:
a) Line up the four captive screws on the UCS Scalability Terminator with the holes on the front of the blade
module(s).
b) Push the UCS Scalability Terminator or UCS Scalability Connector into place.
c) Tighten the captive screws on the front of the UCS Scalability Terminator or the UCS Scalability Connector.
Server Configuration
Cisco UCS blade servers should be configured and managed using Cisco UCS Manager. For details, see the
Configuration Guide for the version of Cisco UCS Manager that you are using. The configuration guides are
available at the following URL:
configuration_guides_list.html
http://www.cisco.com/en/US/products/ps10281/products_installation_and_
Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs
Server Configuration
11