Cisco UCS B460 M4 Nota de instalação e manutenção - Página 28

Procurar online ou descarregar pdf Nota de instalação e manutenção para Servidor Cisco UCS B460 M4. Cisco UCS B460 M4 46 páginas. Blade server
Também para Cisco UCS B460 M4: Ficha de dados (7 páginas), Manual de início rápido (2 páginas), Manual de início rápido (5 páginas), Nota de instalação e manutenção (50 páginas)

Removing a CPU and Heat Sink

If DIMM insertion errors are detected, they may cause the blade discovery process to fail and errors will be

reported in the server POST information, which is viewable using the UCS Manager GUI or CLI. DIMMs

must be populated according to specific rules. The rules depend on the blade server model. Refer to the

documentation for a specific blade server for those rules.

Faults on the DIMMs or rear mezzanine modules also cause the server health LED to light solid amber for

minor error conditions or blinking amber for critical error conditions.

Use the following procedures to remove, replace, or upgrade a CPU.

Procedure

Step 1

Remove any SSDs or blanking panels by squeezing the slide latch and pulling outward. See callout 1 in the

following figure.

Step 2

Unscrew one captive screw on each SSD cage. See callout 2.

Step 3

Slide the SSD cage back and upward to fully remove it. See callout 3.

Step 4

Place the SSD cages next to the sides of the base, keeping all cables connected. See callout 4.

Figure 11: Removing an SSD Cage

Step 5

Unscrew the four heat sink captive screws in the order shown in the following figure.

Note

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

LED diagnostics button on the server motherboard

There and left and right versions of the heat sinks and CPUs. The left heat sink, shown in the following

figure, is for CPU1 and the right heat sink, shown in the following figure, is for CPU 2.

Servicing the Blade Server