Cisco 2800 Series Manual de início rápido - Página 34

Procurar online ou descarregar pdf Manual de início rápido para Porta de entrada Cisco 2800 Series. Cisco 2800 Series 45 páginas. Cisco ios software configuration
Também para Cisco 2800 Series: Manual de início rápido (13 páginas), Ficha de dados (8 páginas), Manual de início rápido (47 páginas), Nota de aplicação (41 páginas), Configuração (10 páginas), Visão geral (27 páginas), Ficha de dados (5 páginas), Ficha de dados (20 páginas), Configuração (32 páginas)

Cisco 2800 Series Manual de início rápido
Step 6
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the

console port:

The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: xxxxxx
Step 7
Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [yes]:
Community string [public]:
A summary of the available interfaces appears:
Note
The interface numbering that appears is dependent on the type of Cisco modular router platform and on the
installed interface modules and cards.
Current interface summary
Controller Timeslots D-Channel Configurable modes Status
T1 0/0/0
24
T1 0/0/1
24
T1 0/2/0
24
T1 0/2/1
24
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
GigabitEthernet0/0
GigabitEthernet0/1
GigabitEthernet0/3/0
Step 8
Choose one of the available interfaces for connecting the router to the management network:
Enter interface name used to connect to the
management network from the above interface summary: fastethernet0/0
Step 9
Respond to the following prompts as appropriate for your network:
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: no
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 16 subnet bits; mask is /16
Step 10 The configuration is displayed:
The following configuration command script was created:
hostname Router
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
media-type 100BaseX
half-duplex
ip address 172.1.2.3 255.255.0.0
!
34
23
pri/channelized
23
pri/channelized
23
pri/channelized
23
pri/channelized
IP-Address
OK? Method Status
20.0.0.40
YES DHCP
unassigned
NO
unassigned
NO
Administratively up
Administratively up
Administratively up
Administratively up
up
unset
up
unset
up
Protocol
up
up
up