Digitus Biometrics dbBioLock Manual de instalação - Página 4

Procurar online ou descarregar pdf Manual de instalação para Por fechaduras Digitus Biometrics dbBioLock. Digitus Biometrics dbBioLock 11 páginas.

Overview

•

If you are installing the lock into to a cabinet that already has a lock installed, remove the existing lock at this time.

For a db BioLock, follow the steps below. If you are installing a db ELock or db CardLock skip

•

The "Door Interface Box" provides an interface between the Remote Node and the fingerprint scanner. It also

provides all power and signal connections to the electric lock.

•

Install the Door Interface Box and electromechanical lock as show in Steps 3 thru 8.

•

Before removing the double-sided high bond tape from the Door Interface Box, find a suitable location on the inside

of the cabinet door to mount the interface box.

•

Ensure that the selected location will not affect the cabinet door from closing correctly.

•

Note that for glass paneled cabinet doors with very narrow frames, the only suitable location may be on the glass.

Ensure that the interface box is located close enough to the lock opening in the door, so that the finger-sensor on the

ribbon cable can go through the door and connect into the lock, see Figure 5.

•

Once you've found a suitable location where you intend to mount the Door Interface Box, ensure that the door

surface is clean and free from any debris. (Using neat alcohol to clean the surface is highly recommended. Allow

drying time before proceeding.)

•

Remove the protective cover from the double-sided high bond tape located along the edge of the Door Interface

Box.

Model: db BioLock, db ELock, db iCardLock

straight to Step 4a.

Figure 3

Page 4 of 11

Digitus Biometrics, Inc. 2014