Cisco Firepower 4600 Manual de instalação do hardware - Página 38

Procurar online ou descarregar pdf Manual de instalação do hardware para Porta de entrada Cisco Firepower 4600. Cisco Firepower 4600 44 páginas.

Imprimir página

Cisco Firepower 4600 Manual de instalação do hardware

Connect Cables, Turn on Power, and Verify Connectivity

Step 2

eth0 management interface (named 1)—Use this interface to perform initial setup using HTTPS, to perform routine

management, and to manage devices from the FMC chassis. Using an Ethernet cable, connect the eth0 interface to your

default management network reachable from your management PC. This interface is the default management interface

and is enabled by default.

Note

You must perform initial setup to change the eth0 IP address to match your network. You can use the

VGA/keyboard CLI for initial setup to set the eth0 IP address, or you can connect your computer directly to

eth0, change the address using the HTTPS initial setup, and then connect eth0 to your network.

Step 3

(Optional) eth1 management interface (named 6)—Connect this management interface to the same or different network

from your other management interfaces depending on your network needs. For information about management interfaces

and network topology, see the

Step 4

eth2 and eth3 management interfaces—If your model includes 10-Gigabit Ethernet SFP+ interfaces, install any

Cisco-supported SFP+ transceivers and cables as needed. You can connect these interfaces to the same or different network

from your other management interfaces depending on your network needs. For more information about management

interfaces and network topology, see the

Each Cisco-certified SFP+ transceiver (SFP-10G-SR) has an internal serial EEPROM that is encoded with security

information. This encoding allows us to identify and validate that the SFP transceiver meets the requirements for the

FMC chassis.

Note

Only Cisco certified SFP+ transceivers are compatible with the 10-G interfaces. Cisco TAC may refuse support

for any interoperability problems that result from using an untested third-party SFP transceiver.

Step 5

Power—Use one of the supported power cords to connect the power supplies of the chassis to your power source. For

more information about supported power cords, see

Step 6

Verify—Press the Power button on the front of the chassis, and verify that the power status LED is on.

Step 7

Setup and configuration—See the

and 4600

to continue setup and configuration.

Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide

Two USB 3.0 Type A ports

You can connect a keyboard, and along

with a monitor on the VGA port, you can

access the console.

eth1 management interface (named 2)

Gigabit Ethernet 100/1000/10000 Mbps

interface, RJ-45

Serial console port

Use the console cable (RJ-45 to DB-9) to

connect a computer to the FMC.

Firepower Management Center Configuration Guide

Cisco Firepower Management Center Getting Started Guide for Models 1600, 2600,

eth0 management interface (named 1)

Gigabit Ethernet 100/1000/10000 Mbps

interface, RJ-45

eth0 is the default management interface.

VGA video port (DB-15 connector)

This port is disabled by default; use the

VGA port and keyboard USB port instead.

Power Cord Specifications, on page

Mount and Connect

for your version.

14.