Cisco Linksys WAG160N Manual do utilizador - Página 7
Procurar online ou descarregar pdf Manual do utilizador para Porta de entrada Cisco Linksys WAG160N. Cisco Linksys WAG160N 20 páginas. Wireless-n home adsl2+ modem router
Também para Cisco Linksys WAG160N: Manual do utilizador (33 páginas), Manual do utilizador (22 páginas)
Imprimir página
Chapter 3
Chapter 3:
Installation
Run the Setup CD-ROM to install the Modem Router. If you
have problems running the Setup CD-ROM, refer to this
chapter.
Connection
1.
Make sure that all the devices that you are working with
are powered down, including your computer(s) and
the Modem Router. If you have a modem connected
to your network, disconnect it. The Modem Router
replaces your modem.
2.
Connect one end of the provided Ethernet cable to
your computer's Ethernet adapter. Connect the other
end of the Ethernet cable to one of the Ethernet ports
on the back of the Modem Router.
Connect the Computer
3.
Repeat step 2 for every computer or device that you
want to connect to the Modem Router via Ethernet. If
you connect more than four computers to the Modem
Router, you also need to connect a switch to the
Modem Router.
NOTE:
If your computer's Ethernet adapter
is not set up, refer to the Ethernet adapter's
documentation for more information.
4.
Connect one end of the phone cable to the DSL port
on the back of the Modem Router.
Connect the DSL
5.
Connect the other end of the phone cable to the wall
jack with ADSL service or microfilter.
NOTE:
To avoid interference, you may need
to place a microfilter or splitter between the
phone cable and wall jack. Contact your ISP to
determine if one is required. (UK residents need
to connect the microfilter to the wall phone jack
with ADSL service and then connect one end
of the provided phone cable to the DSL port
on it.) If you have more than one phone and
you experience static on the line after installing
the Modem Router, then you need to install an
additional microfilter for each phone or fax that
you use. If you use ISDN, then you do not need a
microfilter.
6.
Connect the power adapter to the Modem Router's
power port and the electrical outlet.
Connect the Power
7.
Power on the computer that you want to use to
configure the Modem Router.
8.
The Power, Wireless, and at least one of the numbered
Ethernet (1, 2, 3, or 4) LEDs should light up. If not, make
sure the Modem Router is powered on and the cables
are securely connected.
Connection is complete.
Continue to the "Setup" section.
Setup
For setup, configure the Modem Router to access the
Internet through your ADSL Internet Service Provider
(ISP). Use the setup information provided by your ISP.
Access the web-based utility as described in Chapter
4: Advanced Configuration, page 5, and then complete
the following tabs within the utility:
•
Setup > Basic Setup
•
Wireless > Basic Wireless Settings
•
Wireless > Wireless Security
After
completing
the
www.linksysbycisco.com/support in the web browser's
Address field, and press Enter.
Installation is complete.
Installation
setup,
to
test
it,
enter
4