Cisco MERAKI MR66 Manual de instalação - Página 8
Procurar online ou descarregar pdf Manual de instalação para Porta de entrada Cisco MERAKI MR66. Cisco MERAKI MR66 20 páginas. Troubleshooting mesh communication between access points
Também para Cisco MERAKI MR66: Manual (7 páginas)
Imprimir página
- 1. Package Contents
- 2. Understanding the MR66
- 3. Antennas and Ports
- 4. Pre-Install Preparation
- 5. Power Source Options
- 6. Factory Reset Button
- 7. Led Indicators and Run Dark Mode
- 8. Check and Upgrade Firmware
- 9. Collect Tools
- 10. Collect Additional Hardware for Installation
- 11. Installation Instructions
- 12. Choose Your Mounting Location
- 13. Verify Device Functionality and Test Network Coverage
- 14. Troubleshooting
- 15. Regulatory Information for MR66
Static Assignment
Static IPs are assigned using the local web server on each AP. The following procedure describes how to set the static
IP:
1. Using a client machine (e.g., a laptop), connect to the AP wirelessly (by associating to any SSID broadcast by the
AP) or over a wired connection.
2. If using a wired connection, connect the client machine to the MR66 either through a PoE switch or a PoE Injector.
If using a PoE switch, plug an Ethernet cable into the MR66's Ethernet jack, and the other end into a PoE switch.
Then connect the client machine over Ethernet cable to the PoE switch. If using a PoE Injector, connect the
MR66 to the "PoE" port of the Injector, and the client machine to the "LAN" port.
3. Using a web browser on the client machine, access the AP's built-in web server by browsing
to http://my.meraki.com. Alternatively, browse to http://10.128.128.128.
4. Click on the "Uplink Configuration" tab. Log in. The default login is the serial number (e.g. Qxxx-xxxx-xxxx), with no
password (e.g., Q2DD-551C-ZYW3).
5. Configure the static IP address, net mask, gateway IP address and DNS servers that this AP will use on its wired
connection.
6. If necessary, reconnect the AP to the LAN.
Static IP via DHCP Reservations
Instead of associating to each Meraki AP individually to configure static IP addresses, an administrator can assign static
IP addresses on the upstream DHCP server. Through "DHCP reservations," IP addresses are "reserved" for the MAC
addresses of the Meraki APs. Please consult the documentation for the DHCP server to configure DHCP reservations.
Collect Tools
You will need the following tools to perform an installation:
Collect Additional Hardware for Installation
You will need the following tools to perform an installation:
8