Cisco VG202 Manual de configuração do software - Página 29
Procurar online ou descarregar pdf Manual de configuração do software para Porta de entrada Cisco VG202. Cisco VG202 50 páginas. Voice gateways
Também para Cisco VG202: Manual de instalação do hardware (50 páginas), Manual (10 páginas), Manual de instalação do hardware (48 páginas), Manual de início rápido (19 páginas)
Imprimir página
Chapter 4
Configuring Voice
VG(config)# ip routing
For complete information about global configuration commands, see the Cisco IOS configuration guides
and command references.
Step 6
To configure another interface, enter the exit command to return to the
To configure the Cisco VG for voice traffic, see the VoIP references in the
Step 7
page
Step 8
To exit configuration mode and return to the enable prompt, when you finish configuring interfaces,
press Ctrl-Z. To see the current operating configuration, including any changes you just made, enter the
show running-config command:
VG# show running-config
To see the configuration currently stored in NVRAM, enter the show startup-config command at the
enable prompt:
VG# show startup-config
The results of the show running-config and show startup-config commands differ if you have made
Step 9
changes to the configuration but have not yet written them to NVRAM. To write your changes to
NVRAM and make them permanent, enter the copy running-config startup-config command at the
enable prompt:
VG# copy running-config startup-config
Building configuration. . .
[OK]
VG#
The Cisco VG is now configured to boot in the new configuration.
Auto-Configuration on the Cisco VG202 and Cisco VG204 Voice
Gateways
To configure auto-configuration on the Cisco VG202 and Cisco VG204 voice gateways, follow these
guidelines and procedures:
•
•
•
•
Restrictions for Configuring Auto-Configuration
The following restrictions apply to configuring auto-configuration on the Cisco VG202 and Cisco
VG204 voice gateways before connecting them to the network:
•
OL-16191-01
4-1.
Restrictions for Configuring Auto-Configuration
Auto-Configuration on the Cisco VG202 and Cisco VG204 Voice Gateways
Configuring the Voice Interface for Cisco CallManager
Configuring the MAC Address Convention
The Cisco Unified Communications Manager (CCM) needs to be provisioned with the voice
gateway information.
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
Auto-Configuration on the Cisco VG202 and Cisco VG204 Voice Gateways
prompt.
VG(config)#
"Prerequisites" section on
4-3