Cisco VG320 Manual de instalação - Página 22

Procurar online ou descarregar pdf Manual de instalação para Porta de entrada Cisco VG320. Cisco VG320 26 páginas. Voice gateways

Connecting the Analog Voice Interface to a Distribution Panel

Before you begin

Make sure that you have an RJ-21 cable with Amphenol 50-pin connectors.

For information on RJ-21X/CA21A pinouts, see

Warning

This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do not touch

the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11 port, or the

associated circuit-board when the ringer is active. The ringer is activated by an incoming call. Statement 1042

Procedure

Step 1

Connect the RJ-21 cable from the analog voice multiport to the distribution panel.

Step 2

Secure the cable in place using the strap.

Figure 12: Analog Voice Connection

RJ-21 cable

Ports, Connectors, and Pinouts

The following table summarizes the cable connections between the voice gateway and the network and user

interfaces. Find the port and the equipment or network type in the table and then look at the applicable pinout

table in

Installing the Cisco VG310 and Cisco VG320 Voice Gateways

Distribution panel

RJ-21 cable

Cable Specifications and

Information.

Installing the Cisco VG310 and Cisco VG320 Voice Gateways

RJ-45 cable (through a patch panel) to central

office

Network demarcation

Cable Specifications and

Information.

Distribution panel